Light-For-Me Accu XS User manual

LIGHT FOR ME
user’s manual
Accus 14.4V
Please read the following manual carefully before the first use and keep it for future reference. Failure to follow
this user's manual may lead to malfunction and / and damage to the accu.
Scuba diving is treated as an extreme sport and requires proper training and certification. Using scuba
equipment by an untrained and inexperienced person without proper certification may cause health damage
and even risk of death.
This manual provides information on using, storing and charging the following Light For Me accus. We recommend that you
read it carefully and follow the instructions. Failure to follow the instructions may result in incorrect work of the accu and /
or its irreversible damage.
Detailed technical data of the above accus can be found at www.light-for-me.global
Product list
Before starting the charging process, make sure the ACCU is dry, check carefully the charging point - remove any moisture.
Check the charger - make sure the cable is not torn or cut. To charge ACCU - first connect the charger to the ACCU and then
to the mains. Depending on the type of charger, the charging process is as follows:
If the battery is equipped with two ports - the charging process can be performed through any of them. When charging
the battery, disconnect the light head from the other port.
1) Charger with 1 red and 3 green LEDs:
the device will perform a self-test (each green LED will
blink one after the other) and start the charging process
- each green LED's light means that one third of the
battery is charged. After charging is complete (all three
green LEDs are on), disconnect the charger from the
mains, wait for the charger to turn off, and then
disconnect it from the battery.
2) Charger with 1 red and 1 green LEDs:
the device will start the charging process, which is
indicated by the red LED. After charging is completed -
indicated by the green LED - disconnect the charger
from the mains, wait for the charger to turn off and
disconnect it from the ACCU.
Charging
1/2
XS / XS SM S / S SMBM M- / M- SMBM M+ / M+ SMBM L

Before connecting ACCU to light-for-me RCA head or RCA - E/O cable, check its overall condition. Check the oring placed in
the port connection and grease it if needed. If cut or torn - replace immediately.
Slide back the rotating nut and push the end of the RCA
cable carefully inside the ACCU’s port connection /
charging point (see photo). Twist the nut to the end.
Check if the set works properly.
For light-for-me RCA heads’ or RCA - E/O cable’s usage and storage - refer to a particular product’s manualand the inside
parts.
Usage
Rinse it after each dive, especially salt water dive. Make sure the RCA head or RCA - E/O cable is still connected - otherwise
water may enter the canister through an open RCA port connection and flood it. Dry the ACCU well and check its overall
condition. Light-for-me ACCU should be stored in a dry place. Avoid places where moisture can enter the ACCU. If stored with
RCA head plugged in, make sure the head can’t be switched on by chance.
Storage
2/2
2/2
Troubleshooting
Problem Solution
One of the RCA ports was not
secured after the last charge
and the ACCU was submerged
in water.
The charger is damaged /
not charging properly /
one of its cables is damaged.
The charger requires repair / replacement. Contact an authorized service center /
battery manufacturer.
There is a high probability that the ACCU has been flooded and the battery
package damaged. Contact an authorized service / battery manufacturer as soon
as possible.