Setup & Installation (cont’d)
Lightcloud Installer Application
3a
3Labeling your device
When installing devices, it’s important to keep track of their Device IDs, installation
locations, panel/circuit #s, dimming function, and any additional notes. To organize this
information, use the Lightcloud Installer Application (A) or Device Table (B).
Install the LC Installer Application: LC Installer is available for iOS and Android.
Scan & Install Lightcloud Devices: Scan each device and assign to a room. It’s
recommended that each device is scanned just before or just after being wired so no
devices are missed. The more notes that are given, the easier it is to commission the system.
Send : Once all of the devices have been added and organized, submit the
information for commissioning.
Device Scanner
Enter Manually
PLACE RECTANGLE TO FIT CODE ON LABEL
Scan Device Code
Device Info
SaveCancel
Device ID 0013A2 004 0B62 A4 A
Location
Zone Name
Dimmable
Power Monitoring
Enter Device
Information
Repeatfor
AdditionalDevices
Devices
Add DeviceSend
Office Light - ID 0013A20040B62A4A
Controller
Office Light - ID 0013A20040B62A4B
Sensor
Office Light - ID 0013A20040B62A4C
Dimmer
Office Light - ID 0013A20040B62A4D
Daylight
Office Light - ID 0013A20040B62A4E
Touch
Send
Device Scanner
Enter Manually
PLACE RECTANGLE TO FIT CODE ON LABEL
Office
Office Lights
Device Table
3b
For setup and maintenance,
we provide two Lightcloud
Device Tables with the
Gateway: one that you can
attach to your panel and one
to hand offto a building
manager. Attach the Device
Identification stickers included
witheach device to a row,
then write in additional
information, such as Zone
name, Panel/Circuit Number,
and whether or not a zone
uses dimming.
CONTROLLER DEVICE IDs
Your Site Name
Z ON E NA M E PA N E L /
CIR C U IT # DIMM I N G
Front Desk 2
D E V IC E I D
1
1
2
3
