
Product code: UHETECH600R
This versatile rechargeable inspection
light features a SMD LED worklight that will
provide either a powerful 600 lumen output
floodlight or a bright 100 lumen spotlight.
The magnetic back and magnetic rotating
handle allows the light to
be
attached to most
metal surfaces and set at a convenient angle
for the work
in
hand, the addition
of
two folding
hanging hooks make this light ideal for use
in
many situations.
Battery Recharging
The Tech-Light 600 must
be
fully charged for
a minimum
of
4 hours before being used for the
first time, this will ensure that the battery gives
its best performance now and
on
future
re-charging cycles.
Failure to recharge the light every 3 months
may permanently damage or reduce the
performance
of
the light.
The battery charge does not have to be
fully depleted before recharging.
Using the Charging
Adaptor
While
on
charge the small charging indicator
lamp will glow
red
and will turn green when the
battery
is
fully charged (approximately 4 hours).
The light can
be
charged from any USB
regulated outlet such as a laptop or phone
charger using the correct USB cable.
www.lighthouse-torches.com
Tech-Light&OO
Rechargeable
LED
Inspection
Light
Please note the following
1) For best performance Li-ion batteries
should not be stored for prolonged periods
without being charged at regular intervals.
2) Manufacturers recommend keeping the
battery
in
a state-of-charge
of
40-50 percent
when placing
in
storage. If
in
doubt, keep the
light
in
a higher charged state
in
a cool place.
3) Self-discharge rate
is
approximately
10% per month.
Operating Instructions
The inspection light output functions are
controlled by a sequential switch
on
the front
of
the light. Repeated switch operation will
cycle between the worklight and spotlight
output.
Under optimum conditions, with a full charge,
the light can normally
be
used for 3 hours
in
worklight mode or 9 hours
in
spotlight mode.
To
achieve the best performance from your
Tech-Light 600, always switch the light off
when the battery power begins to
run
low,
and recharge immediately.
Cleaning
Clean the light using a soft cloth
dampened
with a
soap
and
water
solution.
Do not immerse
or
submerge
the
light in
water
or
any
other
fluid.
FAITHFULL TOOLS: 3 White Lodge Business Estate, Hall Road, Norwich, Norfolk, NR4 6DG, United Kingdom.
TUCKS O'BRIEN: 24 Magna Drive, Magna Business Park, Citywest Road, Dublin 24, D24 FNYO, Ireland.