Lightolier LYTESPOT User manual

INSTRUCTIONS FOR AITACHING LYTESPOT” TO
LYTESPAN” TRACK
INSTRUCTION SHEET NO. ‘
IS:6210
R0490
FOR USE WITH BASIC OR ADVENT LYTESPAN TRACK SYSTEMS ONLY.
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.
This fixture is intended for installation in accordance with the National Code and local regulations. To
assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTIONS FOR ATTACHING LYTESPOT TO
SINGLE CIRCUIT TRACK SYSTEMS
1.
2.
3.
4.
Align BEAD on LYTESPAN TRACK and GROOV’E in
FITTING before inserting into LYTESPAN TRACK.
See Fig. 1. (if BEAD is NOT aligned, apotential
hazard may result. )
Position LEVER as shown in Fig. 1.
To attach FITTING, insert into LYTESPAN TRACK.
Turn LEVER 90° to make mechanical and electrical
connection. See Fig. 2.
To remove or shift fixture location on the LYTESPAN
TRACK, reverse procedure as described in #3 above.
NOTE: Lamp manufacturers’ bulb sleeve may state
“Burn only in porcelain sockets.” In certain fixtures phenolic,
not porcelain, sockets are used. These are of aspecial heat
resistant type that have been tested, by Lightolier and are listed
by Underwriters Laboratories for use with the recommended lamps.
INSTRUCTIONSFOR CONVERTINGLYTESPOT
ATTACHMENTFITTING TO OPERATEON
2CIRCUITTRACKSYSTEMS
NOTE; TO insure proper operation of Lytespots on TM
Circuit Lytespan Track, the BLACK SPACER (provided)
must be used at all times on the plug assembly.
The BLACK SPACER is not used when operating Lytespots
on Single Circuit Track.
LOWER CIRCUIT, FIG. 3:
/- LYTESPAN TRACK
,,~
GROOVE
%
LEVER
FITTING
FIG. 1
&
FIG. 2
MOVABLE BRASS BLACK
CONTACT
*
SPACER
o
FIG. 3
‘1MOVABLE 8RASS
Illustrates contacts in low position with spacer in BLACK
b
%*
CONTACT
SPACER STATIONARY
place for lower circuit. CONTACT
----- (Comm.n) BLACK
:- ~SPACER
---
UPPER CIRCUIT, FIG. 4 and 5: 0---- 0
To convert attachment fitting for upper circuit, raise
BRASS CONTACT to high position (as indicated by PLUG
ASSEM8L
dotted line) by pulling CONTACT as high as stop
permits and slipping on BLACK SPACER as shown in FIG. 4
Fig. 4 and 5. FIG. 5