Lilitab Floor Pro Mount Assembly Instructions v4.0 5
ASSEMBLY INSTRUCTIONS
5. Place your Head Unit onto the MagDOCK
in either landscape or portrait orientation.
Turn the key to lock it in place.
WARNING: Not locking the MagDOCK will result in
the unit falling off, possibly damaging the unit and/
or the tablet. The Lilitab Pro is designed to be
operated with the lock closed.
6. Tilt feature. By default the Lilitab Head
Unit can be tilted by the user to suit. If
you wish to disable tilt, position your head
unit at the desired angle and tighten the
bottom screw on the neck joint with the
black L key provided.
Refer to your Lilitab Head Unit owner’s
manual for tablet installation instructions.
3. Connect and position cables:
1. Connect the charge cable to the tablet’s
AC adapter. Then connect the adapter
to your extension cord.
2 . Position both cables underneath the
base housing’s two plastic tabs. The
extension cord should exit the rear of
the housing.
3 . Screw down the base housing using the
two (2) M6x14mm long base screws.
4. Attach the base housing cover by sliding
it into place. Secure it using the two (2)
M3x6mm base security screws and
silver L key.
1. Thread the charge cable that came with
your kiosk through the top of the mount
pole. Insert the mount pole into the base
housing on an angle to clear the welded
flange, as pictured.
2. Attach Floor Base. Line up the bottom of the
mount pole with the four screw holes. Using
the two (2) M6x12mm short base screws,
secure through the two rear-most openings
closest to the cable egress slot.
NOTE: You will need to hold the base housing up
and out of your way while bolting. If not using the
floor base, attach to floor surface using template on
page 6, and thread the cable through your substrate.
(iPad AC adapter shown with optional apple
power extension cord. Your AC adapter will
vary depending upon your tablet type.)
