lilitab Wall Basic User manual

2339 3rd Street, Suite 59 [email protected] San Francisco, CA 94107 t: 888.705.0190 www.lilitab.com
Lilitab Wall Basic Mount
Assembly Instructions
v3.0

Lilitab Wall Basic Mount Assembly Instructions v3.0 2
TO ASSEMBLE YOUR LILITAB YOU WILL NEED:
4 Apple iPad power adapter that came with your iPad
TO MOUNT YOUR LILITAB YOU WILL NEED:
4 4 x flat-head mount screws suitable for your wall surface
PACKING LIST
1 x Wall Basic Mount
2 x Bumper Plate
1 x Silver L Key
TABLE OF CONTENTS
Assembly Preparation and Packing List.............2
Assembly Instructions ...........................3
Scan to watch
assembly videos on
our YouTube Channel!
GOT QUESTIONS? WE’RE HERE TO HELP!
EMAIL [email protected]om PHONE [phone]

Lilitab Wall Basic Mount Assembly Instructions v3.0 3
ASSEMBLY INSTRUCTIONS
1. Use the bumper plate appropriate to your
deployment to mark screw locations
on your wall.
NOTE: If you are routing the charge cable through
your wall substrate, trace the oval opening in the
center of the bumper plate to mark the area that
you will need to cutout to pass the cable through.
3. Attach Wall Basic Mount to bumper plate
using four (4) flathead screws appropriate
for your wall substrate (not included).
NOTE: Ensure the bumper plate is positioned
between the mount arm and wall in the desired
orientation to prevent the unit from hitting the wall
when positioned.
2. Thread charge cable that came with your
kiosk through the top of the wall mount.
Cable can run down/along wall or through
wall substrate.
4. Attach the Head Unit using the four (4)
M3x7mm Head Mount Security Screws
and Silver L Key.
NOTE: Rotating the neck security cover 90° will make
access to the screw openings easier to access.
5. Neck Security Cover. After you attach the
Head Unit, slide the security cover up and
secure in place using the two (2) M3x10mm
Security Cover Screws and Silver L Key.
Refer to your lilitab Head Unit owner’s
manual for tablet installation instructions.