Limbs & Things 70250 User manual

limbsandthings.com
FOR MORE SKILLS TRAINING PRODUCTS VISIT
Sussex Street, St Philips, Bristol, BS2 0RA, UK | [email protected] | [phone]
USER GUIDE
COLLES’
FRACTURE
REDUCTION
TRAINER
70250

2
INDEX
PACKAGE
SUPPLIED
PACKAGE SUPPLIED 2
SAFETY & CLEANING INSTRUCTIONS 3
SET UP 4
•QUICK SET UP 4
•REPLACING THE HAND SKIN 6
CLEANING & STORAGE 8
•CLEANING & STORAGE AFTER USE 8
HEX KEY (x2)
Large (5mm) & Small (2.5mm)
COLLES’ FRACTURE ARM
(includes 70251 Hand Skin)
ADJUSTABLE HEIGHT STAND
STORAGE &
TRANSPORTATION
Always ensure that the products are properly packed and
secured during transportation and storage in order to prevent
personal injury or damage to the product.

3
SAFETY &
CLEANING
INSTRUCTIONS
DO’s DON’Ts
Follow all instructions.
Keep these instructions.
Heed all warnings.
Do not install near any heat sources,
do not expose the product to flames
or use near naked flame sources.
Do not use flammable solvents near
or on this product.
Do not use any attachments
other than those supplied by the
manufacturer.
To avoid tearing when replacing
the hand skin, you can apply talc
to the inside, this will prevent
friction occurring when fitting the
hand skin.
Clean the product with a damp
soft cloth or sponge, using only
warm water with mild detergent,
after every training session.
Tension must be set back to 0
(lowest tension) when product
is not in use.
Apart from hand skin removal, do not
disassemble the product or attempt
to repair a faulty unit, please return
the product to Limbs & Things for
assessment and repair.
Stand not to be pulled on with force
while training.
READ THE SAFETY INSTRUCTIONS CAREFULLY BEFORE
USING YOUR COLLES’ FRACTURE REDUCTION TRAINER
Talc
Powder
Do not allow young children
to use this product.
Do not inject liquid into the product,
it is not intended for anaesthetic
injections.
If a product is damaged or worn, it should
be repaired by Limbs & Things. To arrange
this, please contact your point of purchase
who will be able to provide a repair quote.
Take care when removing cast
so not to damage the skin

4
SET UP
The product is ready
to use out of the box.
An adjustable tension feature allows for progressive levels of difficulty.
TURN
left to tighten
right to loosen
CLICK!
Use the large Hex key

5
SET UP
The stand provides a fixed reference point.
Numerous plastering techniques
can be performed.
Chose the appropriate height
1
2
3
Tighten clamp to secure it
Product to always be used with a minimum of two people,
conducting traction and counter traction, even when using the stand

6
SET UP
REPLACING THE HAND SKIN
Remove the skin securing plate.
Remove the 3 screws.
3
2
4
Use the small Hex key
1

7
SET UP
REPLACING THE HAND SKIN
To replace the skin, reverse this process.
Take particular care when first inserting arm skin over the forearm.
Apply talc on the inside of the
arm skin to make things easier
Talc
Powder

TAKE A LOOK
AT OUR VIDEO
VISIT THE WEBSITE
limbsandthings.com
OR YOUTUBE CHANNEL
youtube.com/limbsandthings
Part No: 965-531
Issue 1, April 2021
© 2021 Limbs & Things
CLEANING
& STORAGE
Clean off any surface dirt with a damp, soft cloth,
using only warm water and mild detergent.