Lincat LYNX 400 LCO Service manual

IS 314 ECN 3607 Page 1 of 7
Installation, Operating and Servicing
Instructions
Lynx 400 Electric Convection Oven
LCO
Please make a note of your product details for
future use:
Date Purchased:_________________________
Model Number:__________________________
Serial Number:__________________________
Dealer:_________________________________
_______________________________________

IS 314 ECN 3607 Page 2 of 7
CONTENTS
Important Information
2
Warnings and Precautions
3
Technical Data
3
Checklist of Enclosures
3
Installation and Commissioning
3-4
Operating Instructions
5
Cleaning
6
Servicing, Maintenance and Component Replacement
6
Fault Finding
6
Spare Parts List
6
Service Information and Guarantee
7
IMPORTANT INFORMATION
Read these instructions carefully before using this product, paying particular
attention to all sections that carry warning symbols, caution symbols and notices.
Ensure that these are understood at all times.
WARNING!
This symbol is used whenever there is a risk of personal injury.
CAUTION!
This symbol is used whenever there is a risk of damaging your Lincat product.
NOTE:
This symbol is used to provide additional information, hints and tips.
KEEP THIS MANUAL FOR FUTURE REFERENCE

IS 314 ECN 3607 Page 3 of 7
WARNINGS AND PRECAUTIONS
This appliance must be installed, commissioned and serviced by a qualified person
in accordance with national and local regulations in force in the country of
installation.
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified person.
Ensure that the plug/socket is accessible at all times.
Strip plastic coating and clean the appliance before use.
During operation parts may become hot - avoid accidental contact.
Disconnect this appliance before servicing, maintenance or cleaning.
TECHNICAL DATA
Model
Height (mm)
Width (mm)
Depth (mm)
Weight (kg)
LCO
371
555
488
25.5
CHECK LIST OF ENCLOSURES
Warranty card
Instructions manual
2 Wire shelves
INSTALLATION AND COMMISSIONING
This appliance must be earthed.
An equipotential bonding terminal is provided to allow cross bonding with other
equipment.
If replacing the plug connect the terminals as follows:
Green and Yellow wire Earth E
Blue wire Neutral N
Brown wire Live L

IS 314 ECN 3607 Page 4 of 7
Supply cords shall be oil resistant, sheathed flexible cable not lighter than ordinary
polychloroprene or equivalent elastomer sheathed cord (code 60245 IEC 57)
Install this appliance on a level surface ensuring all vents are unobstructed. Install
this appliance on a level surface ensuring all vents are unobstructed. Any
partitions, walls or furniture must be of non-combustible material. Minimum
distances A 100mm B 1000mm –see Fig 1.
Fig 1
Power Ratings
Model
kW
Amps
LCO
2.5
10.9

IS 314 ECN 3607 Page 5 of 7
OPERATING INSTRUCTIONS
Only qualified or trained personnel should use this appliance.
Connect the appliance to an electricity supply and switch on –the switch and
interior light illuminate.
Turn the control knob to the desired setting –the amber neon illuminates and
extinguishes when temperature is reached.
The amber neon will periodically illuminate as the element cycles.
This appliance is fitted with a safety thermostat, which will cut power to the
appliance under fault conditions. If the switch illuminates but the appliance does
not heat up, the safety thermostat may need re-setting. Push the red button on the
rear panel (Fig 2 –A). This re-set cannot be activated until the appliance is cool.
Fig 2
CLEANING
Do not use a water jet or steam cleaner, and do not immerse this appliance.