Lincat PO425 Operating instructions

IS395 ECN3364
User and Installation Instructions
Electric Pizza Ovens
PO425, PO425-2, PO430, PO430-2,
PO630, PO630-2

IS395 ECN3364 2
Dear Customer,
Thank you for purchasing this Lincat Product.
This is just one of over 450 different items of catering equipment available
from our range which is constantly being extended and improved. Details are
available from your local distributor or direct from us.
Used for the purposes for which it is intended, and with careful maintenance
as outlined in this user Guide, your Lincat product will give years of trouble
free use.
IMPORTANT INFORMATION
Please read all of the safety and operating instructions carefully before
using this product. Please pay particular attention to all sections of this
User Guide that carry warning symbols and notices.
WARNING!
This is a Warning symbol. This symbol is used throughout the
user guide whenever there is a risk of personal injury. Ensure that
these warnings are read and understood at all times.
CAUTION!
This is a Caution symbol. This symbol is used throughout the User
Guide whenever there is a risk damaging your Lincat product. Ensure
that these warnings are read and understood at all times.

IS395 ECN3364 3
TECHNICAL SPECIFICATION
SAFETY INSTRUCTIONS
Information for you and your staff.
WARNING!
The thermostats used within this unit contain Potassium – Sodium alloy that
react violently with water and can cause burns. Under no circumstances
should the capillary / bulb be cut open.
GENERAL
Do not clean the unit with a water jet.
Do not try to modify this product.
In the interest of hygiene, you should clean the product after unpacking and
ensure all plastic coatings are removed before use.
Ensure that the electrical supply cable is not damaged. If the supply cable is
damaged it should be replaced by Lincat Ltd or other suitably qualified
persons, in order to avoid a hazard.
Disconnect the unit from the electric supply before servicing or undertaking
any electrical maintenance.
This unit must be earthed.
Model PO425 PO425-2 PO430 PO430-2 PO630 PO630-2
Width mm 886 886 966 966 1286 1286
Depth mm 902 902 1002 1002 1002 1002
Height mm 375 675 375 675 375 675
Power Rating watts 3000 6000 4200 8400 7200 14400
Single / Three
phase Single only
Single,
Three
Single,
Three
Single,
Three
Single,
Three
Three
only
Weight (net) kg 58 101 77 135 104 181

IS395 ECN3364 4
INSTALLATION
PACK CONTENTS
All models
Electric Pizza oven
User instructions
Guarantee card
The PO range of Pizza ovens operate up to 480 deg C Your pizza oven
should ideally be sited in a dry well ventilated environment, with a gap
of at least 100mm between the back and sides of the unit and adjacent
walls or other appliances.
The base of your pizza oven will become hot and therefore should not be
placed directly onto wooden or Formica surfaces, also a gap of 25mm should
be kept between the unit and the surface on which it is situated. The height of
the unit can be set by adjusting the screw feet.
For safety regulations, the plug must always be accessible.
CONNECTING TO THE ELECTRICITY SUPPLY
Ensure that the voltage of your electricity supply corresponds to the
serial plate details.
The PO425 product is supplied with a 13 amp plug. To replace the plug,
follow these instructions:
•green and yellow wire to 'E' or (Earth)
•blue wire to 'N' (Neutral)
•brown wire to 'L' (Live)
All other units are fitted with a terminal connection box labelled
1 Live 1 Brown
2 Live 2 Black
3 Live 3 Grey
N Neutral Blue
N Neutral Blue (to be connected to other N terminal with the
supplied link.)
E Earth Green / Yellow
For wiring options for all units see the specification table on page 2.

IS395 ECN3364 5
OPERATING INSTRUCTIONS







Fig 1.
1 Green Neon. Power on indicator
2 Amber neon Top element on neon
3 Amber neon Bottom element on neon
4 Top element thermostat
5 Bottom element energy regulator
6 Oven temperature indicator
7 Oven timer, 20 minutes
USING THE OVEN
Connect the unit to the electricity supply.
1. With the all switches and control knobs in the off position, switch the unit
on at the isolator. The green neon will illuminate.
2. Turn on the top rotary control knob, the light will come on and the desired
oven temperature can be set.
3. Set the energy regulator to 3 to preheat the unit.
4. The amber neons will illuminate to show that the elements are turned on.
The thermostat amber neon will go off when the unit has reached the required
temperature. The energy regulator setting is a recommendation and should be
adjusted to suit individual requirements. The lower amber neon will only be lit
when the lower element is on and will cycle on and off as the energy regulator
controls the power to the bottom element. The energy regulator should not be
left on maximum.
To turn the unit off, turn the top control knob to ‘0’

IS395 ECN3364 6
Safety (High Limit) Thermostat
All units are fitted with a high limit safety stat to protect the unit in event of the
control thermostat failing. Twin units are fitted with two safety thermostats,
one per oven
Note: The re-set button cannot be activated until the unit has cooled
sufficiently

1 Re-set button (safety thermostat)
Fig 2.

IS395 ECN3364 7
SERVICE INFORMATION
CLEANING AND MAINTENANC
E
CLEANING
Disconnect the unit from the electricity supply and allow it to cool
before starting to clean. Use a mild detergent in hot water and a soft
cloth. Do not use abrasive creams or scourers.
Occasionally, carefully remove the pizza stone and sweep out any debris from
the base if the unit.
MAINTENANCE
Regular cleaning of the unit is recommended.
No regular maintenance is required.
For help regarding the installation, maintenance and use of your Lincat
equipment, please contact our service department:


01522 875520
All service work, other than routine cleaning should be carried out by one of
our authorised service agents. We cannot accept responsibility for work
carried out by other persons.
To ensure your service enquiry is handled as efficiently as possible, you need
to have the following details available:
•Brief details of problem
•Product code, type number and serial number of unit (both on
serial plate)
Lincat reserve the right to carry out any work under warranty during normal
working hours, ie Monday to Friday, 08:30 a.m. – 17:00 p.m.

IS395 ECN3364 8
GUARANTEE
This unit carries a comprehensive UK twelve-month warranty. The
guarantee is in addition to, and does not diminish your statutory or legal
rights.
The guarantee does not cover:
•Accidental damage, misuse (or use not in accordance with the
instructions in this User Guide)
•Consumable items.
•Damage due to incorrect installation, modification or unauthorised
service work.
•The manufacturer disclaims any liability for incidental, or consequential
damages.