Linde H 50 - 02 User manual

IC Sit-Down Rider Trucks
SAFETY TIPS
and a guide to the
Information Plates,
Operation and Warning Decals
found on your truck
LINDE LIFT TRUCK CORP.
A MEMBER OF THE LINDE GROUP
161970 February 2003

2
SAFETY TIPSSAFETY TIPS
SAFETY TIPSSAFETY TIPS
SAFETY TIPS
Foreword
This Operator's Manual is not a training manual. It is a guide to help Operators safely
operate their equipment by pointing out the correct methods and procedures. The
Operator's Manual cannot cover every possible hazard or potential accident situation.
It is up to you, the Operator, to avoid or correct these potential dangers. It is important
that you know and understand the information in this manual as well as the equipment
you will be operating. Do not operate a damaged or malfunctioning truck. Practice
safe operation every time you use your lift truck so that we can join together to set
high standards for safety.
The lift truck is designed for lifting and transporting of pallets or loads of material. The
truck is designed for operation on smooth and dry surfaces. The truck has the ability
to climb or descend smooth and dry ramps with or without a load. Ensure you use the
truck only for the job it was intended to do.
NOTE:
The descriptions and specifications included in this manual were in effect at
the time of printing. Linde Lift Truck Corporation reserves the right to make
improvements and changes in specifications or design without notice and
without incurring obligation. Please check with your authorized Linde dealer
for information on possible updates or revisions.
Regular care and maintenance of your truck is not only important for full and efficient
truck life, it is essential for equipment and Operator safety. The importance of
maintaining the truck in a safe operating condition with regular planned servicing and
prompt repairs when necessary cannot be emphasized too strongly. Experience has
shown that powered industrial trucks can cause injury if improperly used or maintained.
To assist in keeping your truck in service and in good operating condition, a
Maintenance section is included in this manual.
The section outlines maintenance and inspection procedures to be done at regular
intervals. These procedures are considered essential to the life and safe performance
of your truck.
The following highlighted data and information are used in this manual to ensure safe
operating and maintenance procedures. Heed them.

3
SAFETY TIPSSAFETY TIPS
SAFETY TIPSSAFETY TIPS
SAFETY TIPS
NOTE:
Indicates information or points of particular interest for more efficient and
convenient operation.
This manual contains operating and periodic maintenance instructions as well as
specifications for the lift truck. The manual is designed to assist in the proper care
and maintenance of your truck while providing maximum safety and efficient operation.
Consider this manual a special tool which, if properly applied, can help ensure years
of safe and efficient material handling. Your local dealer or the factory can arrange for
Operator training and/or maintenance instructions for your truck should you need
them.
Parts and Service
See your Linde dealer for genuine Linde parts (the only factory-authorized
replacements), factory-trained service personnel and manuals for your equipment.
General Safety Rules
Safety signs and messages are placed in this manual and on the truck to provide
instructions and identify specific areas where potential hazards exist and special
precautions should be taken. Know and understand the meaning of these instructions,
signs, and messages. Damage to the truck, death or serious injury to you or others
may result if these messages are not followed.
INDICATES A POTENTIALLY HAZARDOUS SITUATION, WHICH IF NOT
AVOIDED, MAY RESULT IN MINOR OR MODERATE INJURY. IT MAY ALSO
RESULT IN DAMAGE TO YOUR MACHINE.
INDICATES A POTENTIALLY HAZARDOUS SITUATION WHICH IF NOT AVOIDED
COULD RESULT IN DEATH OR SERIOUS INJURY.
DANGE
R
INDICATES AN IMMINENTLY HAZARDOUS SITUATION WHICH IF NOT AVOIDED
WILL RESULT IN DEATH OR SERIOUS INJURY.
You, as the Operator, are ultimately responsible for your own safety and the safety of
those around you. Read and Study this manual. Be sure to understand all the
operating procedures and safety precautions before operating the truck.

4
SAFETY TIPSSAFETY TIPS
SAFETY TIPSSAFETY TIPS
SAFETY TIPS
The Occupational Safety and Health Act (OSHA) states, “The employer shall ensure
that each powered industrial truck operator is competent to operate a powered
industrial truck safely, as demonstrated by the successful completion of the training
and evaluation specified in this paragraph.” Do not attempt to operate this truck
unless you are fully trained and authorized.
Before Operation
Before using the truck, inspect your work area. Check that it is neat, well lit, adequately
ventilated, and free from hazardous material. Aisles and roadways should be
unobstructed and well marked.
Fire extinguishers and other emergency equipment should be visible and easy to
reach. Wear safety equipment when required. Don’t smoke in “No Smoking” areas,
when refueling. Don’t mix drugs or alcohol with your job.
The truck is designed for safety. Unauthorized additions or modifications without
Linde’s approval are prohibited. Do not remove or alter nameplates.
If you have any questions or concerns about lift truck safety, talk to your supervisor. If
an accident should occur, report it immediately.
Start the engine only when securely seated in the operator’s compartment.

5
SAFETY TIPSSAFETY TIPS
SAFETY TIPSSAFETY TIPS
SAFETY TIPS
Do not remove any safety guards or other safety devices. These include the Overhead
Guard, Load Backrest Extension, and if equipped by the Owner, alarm, lights and
mirrors.
The Overhead Guard is intended to provide protection to the Operator from falling
objects, but cannot protect from every possible impact.
OPERATOR’S DAILY CHECKLIST
At the beginning of each shift, inspect your truck by using the Linde Operator’s Daily
Checklist . Check for damage and maintenance problems. Have repairs made
before you operate the truck.
Checklist for IC Sit-down Trucks

6
SAFETY TIPSSAFETY TIPS
SAFETY TIPSSAFETY TIPS
SAFETY TIPS
Do not make repairs yourself. Lift truck mechanics are trained professionals. They
know how to make repairs. Periodic maintenance is vital to safe operation of the
truck. Adhere to a strict inspection, lubrication, and maintenance schedule. Allow
only authorized personnel to work on the truck.
Do not operate a damaged or defective lift.
If warning decals are damaged or missing, they must be replaced.
Know your Truck’s capacity. The capacity of your truck is listed on the Capacity Plate.
Read and understand the Capacity Plate. The capacity of your truck is listed on the
Data Plate. Never attempt to lift or transport a load exceeding the truck’s rated
capacity.
Never attempt to lift or transport a load exceeding the trucks rated capacity.

7
SAFETY TIPSSAFETY TIPS
SAFETY TIPSSAFETY TIPS
SAFETY TIPS
PEDESTRIANS
Watch out for pedestrians. Always yield the right-of-way to pedestrians. Do not drive
the truck up to anyone standing in front of a rack or other fixed object. Do not pass
another truck traveling in the same direction at an intersection, blind spot or other
dangerous location. Sound horn at intersections and other locations where vision is
obstructed. Always look in the direction of travel.
If your vision is restricted, then operate the truck in reverse. Be sure to pivot in your
seat to the right to provide maximum visibility to the rear.

8
SAFETY TIPSSAFETY TIPS
SAFETY TIPSSAFETY TIPS
SAFETY TIPS
Do not engage in stunt driving or horseplay. Use lights in dark and dim areas. Always
ensure that there are no pedestrians in the trucks rear swing area before turning.
Watch for pedestrians beside the truck.
DANGE
R
Watch for people in your work area because they may not watch for you, even if you
have lights or alarms.

9
SAFETY TIPSSAFETY TIPS
SAFETY TIPSSAFETY TIPS
SAFETY TIPS
149569
W
ARNING
KEEP HANDS CLEAR.
SERIOUS INJURY COULD RESULT.
OPERATING POSITION
Face the truck when mounting and dismounting. Maintain a three-point contact, one
foot and two hands with the truck when mounting or dismounting. Never exit a moving
truck. Never jump on or off the truck.
Operate the truck only when you are in the normal operating position. Keep hands
and feet inside the Operator’s Compartment.
Keep hands, feet and legs out of the upright.

10
SAFETY TIPSSAFETY TIPS
SAFETY TIPSSAFETY TIPS
SAFETY TIPS
DANGE
R
Never allow anyone to walk under raised forks.
Wear your seat belt at all times when operating the truck.