
Front door
folding with
tempered glass
Side
Folding
Protected cable
pass-through
with cover
Drilling for wiring,
just remove the cover.
Rear door
with
ventilation
Rails with racking
adjustment in
increments of 1 "
Preparation
for 2 fans
(Not included)
Introduction
Thank you for selecting our Rack cabinet SR1928FV3,
SR1965GACV2 or SR1980GACV2. The information contained in.
This manual will help you in the assembly of the product in
addition to nd the physical characteristics, including parts and
recommendations for use.
Recommendations
Start to Install the equipment (s) only until the cabinet has been
installed. The cabinet is detachable, so it is possible to decrease
your volume in case you need to send it to a more distant
location.
Installation / Operation Mode
Install the cabinet on a surface as straight as possible. Use the
levelers in the lower part to compensate any remaining slope.
For greater ease of installation of equipment, you can remove
both doors and side to have full access to the cabinet. Once
installed the equipment, place the sides again and nish
placing the doors. Both doors are folding and can be installed
to vary its left or right turn.
Screws Included
12 Philips 10-32 tapered screw.
•
12 pressure nuts for rack.
•
12 Tapered nylon washer.
•
Folding side doors only withdrawing screws
as shown. You need the key of the doors to
access to the screws.