Linksys PAP2-T User manual

Linksys PAP2T Setup and VoIP Configuration Guide
Before You Begin, make sure you ha e the following:
• An acti e Internet connection
• An acti e Internet phone ser ice account and its settings
• A cable/DSL modem
• One computer for configuration of the Phone Adapter
• An analog telephone or fax machine with an RJ-11 phone cable.
I. Connect the Phone Adapter
STEP 1 Connect the included Ethernet network cable to the INTERNET port of the Internet Phone
Adapter. Connect the other end to one of your router’s Ethernet ports.
STEP 2
Connect the included power adapter to the POWER port of the Internet Phone Adapter.Connect the
other end to an electrical outlet.
STEP 3 Using a telephone cable, connect your telephone to the PHONE 1 port of the Internet Phone
Adapter.
STEP 4 If you ha e a second Internet phone ser ice account, then connect another telephone or a
fax machine to the PHONE 2 port of the Internet Phone Adapter.
STEP 5 The Power, Ethernet, and Phone LEDs will be solidly lit when the Internet Phone Adapter is
ready for use.

II. Configure the Phone Adapter
STEP 1 Determine the PAP2T IP address to access the web interface
•Dial ****110#
•Listen to IP Address which is read back to you (e.g. 192.168.0.1).
STEP 2 Launch the web browser on the PC where the IP Address was pro ided in STEP 1.
http://<IP Address>/
Example: http://192.168.0.1/
STEP 3 Click on the "Admin Login" button near the top right side of the screen, then click on the
"Line 1" tab.
STEP 4 Next, choose from the main menu 'Voice' and then Line1. Enter your Asiadigicall VOIP
number into the User Id: field and Asiadigicall SIP password into the Authenticate Password: field.
Enter 221.133.209.9 into Registration/Proxy Ser er: field. Repeat Step 5 for line 2.
Example:
Proxy: 221.133.209.9
Display Name: Enter your full name, this will show up as part of your callerid.
User ID: 61055001000
Password: 123456
Register Expires: 3600
STEP 5 Click on the "Sa e Settings " button at the bottom of the form.
STEP 6 Make Calls!