Lipman NURIT 8000 User manual

Credit Card Sale Debit Sale Forced Sale
›Swipe Card
›Press for Credit Card
if Prompted, or Skip to Next
Step
› Amount +
›Swipe Card
›Press for Debit Card
Or
›Press
Until Debit...Sale Appears on
the Screen Then Swipe Card
›Amount +
›Cash Back +
›Press if No Cashback
›PIN Number +
›Press
Until Credit...Forced
Appears on the Screen
›Swipe Card
Or Enter Acct Number +
›Exp. Date +
›Amount +
›Enter Auth Number +
NOTE:
*CVV2 (also CVC2 and CID) codes are often requested for manually entered transactions. These codes normally appear on the
back of the card as the last three digits on the right of the signature panel, directly below the mag stripe.
Use numbers only for street address.
-Terminal will prompt for Clerk ID and invoice number if those options are activated.
›Press
Until Credit...Return
Appears on the Screen
›Swipe Card
Or Enter Acct Number +
›Exp. Date +
›Amount +
›Enter Acct Number +
›Exp. Date +
›Amount +
Card Present?
›Press for Yes
›Or for No
› Enter Zip Code +
› Street Address+
›Enter CVV2, CVC2, or CID
Code* +
› Enter Order Number* +
Manual Credit Card Sale Credit Card Refund Voids
R ETAIL
Enter
Paymt
Menu
Cancel
Enter
Paymt
Enter
Paymt
Enter
Paymt
Enter
Paymt
Enter
Paymt
Enter
Paymt
If code is not known or not present, press
and choose the appropriate numeric response.
*These items above prompt if the card is not present. Discover
cards will prompt when the card is present as well. The AVS
and CVV2 or CID response will print on the receipt.
Enter
Paymt
Enter
Paymt
Enter
Paymt
›Press
Until Credit...Void/Sale
Appears on the Screen
›Swipe Card
Or Enter Acct Number +
›Exp. Date +
›Amount +
Enter
Paymt
Enter
Paymt
Enter
Paymt
The terminal will look for a transaction that matches the data
entered to VOID, or it will read. “Trans not found” if no match.
Enter
Paymt
Enter
Paymt
Enter
Paymt
Enter
Paymt
Enter
Paymt
Enter
Paymt
Use the six digit authorization number previously obtained
for this transaction. The receipt will read “Ticket Only”.
Enter
Paymt
Enter
Paymt
Enter
Paymt
Enter
Paymt
Enter
Paymt
Menu
Cancel
Enter
Paymt
Press again to VOID a Return, or again
to VOID a Forced Sale.
The Nurit 8000 is a wireless terminal with an internal radio antenna and battery pack. The terminal will turn itself off if idle for more
than one minute to conserve the battery power. To turn the terminal back on, press and hold down for two seconds. To charge
the battery, plug the terminal into a standard power outlet using the power pack provided. It is recommended that the terminal be
charged for 12 hours upon receipt, and about two hours for recharges.
To manually turn the terminal off, press and at the same time.
There is a battery status graphic in the lower left corner of the screen. A radio connection and signal strength indicator is in the
lower right corner. When first powered on, this will say “RAD FAIL.” After a radio connection is made (5-40 seconds) a number
should display here to indicate the strength of the connection. A signal of at least 14 is recommended.
On/Off
F
On/Off
Enter
Paymt
Enter invoice number or just press the key
and then press the key.
1
Enter
Paymt
Quick Reference Guide
Nurit 8000
05BAM066_N8000.Ret.B.1.Doc 4/18/05 3:18 PM Page 1

NOTE:
Duplicate Card Verify History Report
Batch Review Current Report Settle Batch
›Press
›Use the Key to Select
Credit, Debit, Cash or Total.
›Then Press
›Press
›Press
for Reports
›Press
for a Detailed Report
›Press
›Press
for Batch
›Press
for Batch To Host
-Or-
›Press
To Batch All Hosts
›Press
Until Credit...Verify
Appears on the Screen
›Swipe Card
Or Enter Acct Number +
›Exp. Date +
›Amount +
Card Present?
›Press for Yes
›Or for No
› Enter Zip Code +
› Street Address+
›Enter CVV2, CVC2, or CID*
Code +
›Press
›Select 1, 2 or 3 (See Below)
To Print Last Customer Receipt
›Press
To Print Any Receipt
›Press
Then Choose the Card Type
2, 3 or 4, and Enter the
Transaction Number +
To Print Last Merchant Receipt
›Press
›Press
›Press
For Reports
›Press
For History Report
Select 1 for Totals
Or 2 Per Batch
Menu
F
R ETAIL
MMDP00148 Rev. 04/05
Nurit 8000
On/Off
1
2
Enter
Paymt
3
Enter
Paymt
Enter
Paymt
Enter
Paymt
Enter
Paymt
Menu
Cancel
*Will prompt if card is not present. If code is not known or not
present, press and choose the appropriate numeric response.
Enter
Paymt
Enter
Paymt
Enter
Paymt
1
3
Enter the six digit date needed for beginning
of report or press for date on screen.
Enter the six digit date needed for end
of report or press for date on screen.
Follow display prompts to select EDC,
card and transaction types needed on report
or press three times for ALL.
Enter
Paymt
Review the transactions in order of transaction number
using the Key to go to the next transaction.
Use the Key to go to the previous transaction.
12
Enter
Paymt
Enter
Paymt
*CVV2 (also CVC2 and CID) codes are often requested for manually entered transactions. These codes normally appear on the back
of the card as the last three digits on the right of the signature panel, directly below the mag stripe.
Use numbers only for street address.
-Terminal will prompt for Clerk ID and invoice number if those options are activated.
Enter
Paymt
Enter
Paymt
Enter
Paymt
Enter
Paymt
Alpha
Menu
Cancel
Enter
Paymt
05BAM066_N8000.Ret.B.1.Doc 4/18/05 3:18 PM Page 2