Lippert Flow Max RV User manual

TI-480 CCD-0007865
www.lci1.com
LippertNOW
LippertNOW
REV: 09.19.2023
Flow Max RV Toilet
Flush Ball Assembly Kit
KITCHEN AND BATH
Installation Guide

TI-480 CCD-0007865REV: 09.19.2023 Page 2
Parts List
Flush Ball Seal Assembly Kit (2022121984)
Letter Part # Description Qty.
A2023028024 Flush Ball Seal 1
Resources Required
∆Silicone Spray or RV Toilet Seal
Lubricant
∆Gloves
∆Paper Towels
∆Seal Conditioner
Preparation
1. Clean the toilet using RV toilet approved cleaners and a soft brush.
NOTE: Only use RV toilet approved cleaners.
2. Turn o the water supply to the FlowMax toilet.
A

TI-480 CCD-0007865REV: 09.19.2023 Page 3
Preparation
Installation
1. Depress pedal (Fig. 1A) as if you were
ushing.
2. Wearing gloves, reach into toilet and pull
out the existing ush ball seal (Fig. 1B) and
safely discard.
3. Use a paper towel and approved cleaner to
clean ush ball seal area.
4. Take new ush ball seal (Fig. 1C), at side
DOWN, and install into lip immediately under
the bowl.
5. Make sure the ush ball seal does not fall
into the tank.
Fig.1
C
B
A
Post-Installation Verication
Immediately After Installation
Make sure FlowMax toilet will ush correctly by depressing the pedal.
Once condent toilet will ush, apply lubricant and seal conditioner. Allow seal conditioner
to cure for 8 to 24 hours.
After Seal Conditioner has Cured
Turn on water and perform a ush test to make sure FlowMax will hold water.

REV: 09.19.2023 www.lci1.com
LippertNOW
LippertNOW
TI-480 CCD-0007865
Manual information may be distributed as a
complete document only, unless Lippert provides
explicit consent to distribute individual parts.
All manual information is subject to change without
notice. Revised editions will be available for free
download at lippert.com. Manual information is
considered factual
until made obsolete by a revised version.
Please recycle all obsolete materials and contact
Lippert with concerns or questions.
Whenever, wherever, we make
your experience better.