
2
AC//DC adopter (120V/12V, 200mA) jack into DC input, put you
audio source into Audio input jack, pull up the ANTENNA. Press the
ON/OFF switch, the LED light, then working on.
2. You can turn the transmitter’s audio input volume, acquire a good
listen effect.
3. If the LED light darkle, its need to recharge the battery.
Warning
Changes or modifications to this unit not expressly approved by the
party responsible for compliance will void the user's authority to operate
the equipment. Any change to the equipment will void FCC grant. This
equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: