2
WARNING:
Risk of re or electric shock. High Bay luminaire installation requires knowledge of luminaires electrical systems. If not qualied, do
not attempt installation. Contact a qualied electrician.
Be certain electrical power is OFF before and during installation and maintenance.
High Bay luminaire must be connected to a wiring system with an equipment – grounding conductor.
Make sure the supply voltage is same as the rated luminaire voltage
Only those open holes indicated in the photographs and/or drawings may be made or altered as a result of this kit installation. Do not
leave any other open holes in an enclosure of wiring or electrical components.
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or sharp objects.
No user serviceable parts inside of High Bay Lumiaire.
Secure heat sink with safety cable.
Tools typically used for base product installation:
Wire Stripper (optional)
Wire Cutter (optional)
PLEASE READ ENTIRE DOCUMENT BEFORE INSTALLATION
HB125, 150, 185, 200 and 220 series luminaires with and without dimming.
Standard: Glass lens (frosted and clear) suitable for wet locations (IP66 rated).
Optional: Shatterproof polycarbonate lens (frosted and clear) suitable for wet locations (IP66 rated).
Note: Save these instructions for future reference.
Section 1- INSTALLATION PROCEDURE-BASE PRODUCT 5
Section 2-YOKE MOUNTING (ACCESSORY) 7
INTRODUCTION & TABLE OF CONTENTS
INSTALLATION AND ASSEMBLY INSTRUCTIONS
SAFETY INSTRUCTIONS AND WARNINGS
Congratulations on the purchase of your LED High Bay. It is usable alone or with a range of accessories. Instructions for
some of the most popular of these are included here.