Litter-Robot Open Air User manual

5 lbs
HANDLE
BONNET
GLOBE
KEY
POWER INPUT
CAT SENSOR
Have a new kitten?
Cats must weigh 5 lbs or more to safely
use the Litter-Robot unattended.
Watch the video.
Watch the Getting Started video at
www.litter-robot.com/gettingstarted

LITTER-ROBOT.COM

QUICK START GUIDE

LET’S GET STARTED!
Your Litter-Robot ships fully assembled. Follow these steps to get
started and refer to the Instruction Manual for more information.
INTERNAL SHIELD
BONNET
BASE
CAT ENTRY/EXIT GLOBE
POWER BUTTON
CONTROL PANEL
INDICATOR LIGHTS
Get to know the main components
of your Litter-Robot.
WASTE DRAWER
STEP MAT
CARBON FILTER
NIGHT LIGHT

GETTING READY
1
Remove the cardboard spacer
between the Bonnet & Globe and
between the Waste Drawer & Base.
Remove the tape from around
the entryway.
Confirm that the side and rear
Bonnet tabs on both sides of
the unit are secured in their
corresponding slots.
Confirm that the Key on the
rear of the unit is located in
the pocket.
Ensure the Shield is in the track and
positioned in the upper corner.
(Key must be in the pocket as shown below.)
WHAT’S IN THE BOX1.1
PRE-CHECK1.2
• 15 Volt DC Power Supply
• Instruction Manual
• Quick Reference Guide
• Quick Start Guide
• Return & Repack Instructions
Welcome Kit
(1) Fully assembled Litter-Robot III Open Air
(1) Carbon Filter
(3) Waste Drawer Liners
SHIELD

SETTING UP YOUR LITTER-ROBOT
2
ENSURE PROPER PLACEMENT
ADD LITTER
2.1
2.2
When filling the Litter-Robot for the first time, it is best to continue using the brand of litter you were using
previously—as long as it is a clumping type of litter. If you are currently using a non-clumping litter, you will need
to switch to a clumping type. Please note, your cat will need to adjust to the new litter box, and introducing a
new litter at the same time may increase their anxiety.
The Litter-Robot litter siing system requires clumping litter to work properly. We recommend a high quality
clay clumping litter. Litter beads and crystals that are small enough to pass through the screen will also work
(periodic changing of this type of litter is required).
• If possible, place the Litter-Robot in the same location as the
old litter box (at least during transition).
• Make sure the unit is on a firm, level surface.
Avoid so, uneven, or unstable flooring.
• Keep the unit indoors in a cool, dry location.
Reduce exposure to high temperature and humidity.
• Place the unit near a power outlet. Ensure the unit isn’t
pushed against a wall or into a corner (must not be touching
any walls).
• Place litter mats or rugs in front of, or completely under, the
unit. Do not place mats partially under the unit. Use only low
pile (¼ inch) rugs and mats.
If you are not sure if your current brand of litter is right for the Litter-Robot, contact us at [e-mail].
DO NOT use litters that are strictly absorbent, non-clumping, loose-clumping, newspaper-based, or
wood-based pellets.
Fill the Globe through the opening with clumping litter until it meets the raised Fill Line when spread flat
(about 8-10 pounds by weight or 1 ½ gallons by volume).
FILL LINE
Be careful not to overfill the Globe.

PLUG IT IN
INITIAL CLEAN CYCLE
READY FOR USE
Your Litter-Robot is now ready to use; however, we recommend powering the unit o until your cat becomes
familiar with the Litter-Robot and begins using it regularly. See the next page for tips on how to introduce
your cat to the Litter-Robot.
Plug the small end of the Power Supply into the socket on the back of the Base. Then plug the AC/DC
adapter into a wall outlet.
3.1
3.2
3.4
Locate and press the Power button. The Litter-Robot will perform an initial Clean Cycle that will last about
2 ½ minutes.
When your cat exits, a timer counts down, allowing litter to clump before a Clean Cycle begins:
1) As the Globe slowly rotates, 2) the patented siing process separates the clumps from the clean litter,
3) depositing them into a carbon-filtered drawer below. 4) The Globe returns to the Home position, leaving
a clean bed of litter for the next use. 5) Empty the Waste Drawer when indicated and add litter as needed.
HOW THE CLEAN CYCLE WORKS
3.3
Did you purchase the WiFi-enabled Litter-Robot Open Air with Connect?
If so, please follow the onboarding instructions included in the Welcome Kit. Want to make your Litter-Robot
compatible with the app? Install the Connect Upgrade Kit, available at www.litter-robot.com/upgrade.
3POWER AND INITIAL CLEAN CYCLE
12345

4INTRODUCING YOUR CAT TO THE LITTER-ROBOT
LR3-8010-0a
Enjoy your freedom from scooping!
Most likely, your cat will quickly adapt to the Litter-Robot. Here are some ways to facilitate
the transition:
4.1
4.2
4.3
4.4
4.5
4.6
LOCATION IS KEY
Place the Litter-Robot in the same location as the current litter box, set it up (make sure you add litter to the
Globe), and make sure it is turned o. Give your cats a day or two to explore the Litter-Robot. If your cats show no
interest, entice them to approach the Litter-Robot by using some catnip or a favorite treat.
FAMILIAR SCENTS
Add a scoop of litter from the old litter box to the Litter-Robot to provide a familiar scent for your cat.
USE TREATS
Place treats on the step or around the Litter-Robot so your cat associates rewards with the unit.
INTRODUCE THE CLEAN CYCLE
Once you notice that your cats have used the Litter-Robot, power the unit on to cycle the unit. Encourage your
cats to be present, so they can observe the motion and become familiar with the sound of the Litter-Robot while
you are there to reassure them. Turn the unit o again once the cycle is complete (the Litter-Robot should be
in the Home position). We recommend that you no longer clean the old litter box once your cats have used the
Litter-Robot.
MAKE THE OLD LITTER BOX LESS ATTRACTIVE
If your cats are not using the Litter-Robot within a few days, continue using the old brand of litter in the old litter
box, and let it go as long as possible without cleaning it. Cats prefer a clean litter box and a dirty litter box might
persuade them to use the clean Litter-Robot. Also consider replacing the litter in the Litter-Robot with a litter
specifically formulated for litter box training.
SAY GOODBYE TO SCOOPING
Once your cats are consistently using the Litter-Robot, you can turn the unit on and leave it on to operate in
Automatic Mode.
If you have any questions, our customer service team is ready to help.
You can reach us M-F, 9am to 7pm ET.
[phone]
[e-mail]
support.litter-robot.com
Phone:
Email:
Troubleshooter:
Need help?