4 EN
SAFETY CAUTION
KEEP AWAY FROM WATER
• Only use this appliance for its intended purpose. Use only on clean dry hair.
• Close supervision is necessary when this appliance is by or near children.
• The appliance is not to be used by persons (including children) with reduced physical sensory or
mentalcapabilities,orlackofexperienceandknowledge,unlesstheyhavebeengivensupervisionor
instruction.
• Useonlywithaccessoriesincludedinthepackage,orrecommendedbythemanufacturer.
• Avoidcontactwiththeeyearea,anddamagedorsensitiveskin.
• Neveruseinbathingareasorwhilewashingwetanimals,toavoidshock.
• Keep away from water or any detergent.
• Do not use the appliance with wet hands, in a damp environment or on wet surfaces.
• Do not immerse the appliance in water. Never reach for any electrical appliance that may have fallen
into water.
• Themainschargeradaptorandclippermustbekeptdryatalltime.
• Do not pull, twist or wrap the cord around clipper.
• Do not operate the appliance with damaged cord or mains adapter, or if damaged, dropped, hit or
exposed to any liquid, snow or water.
• Do not use any other mains adapter and never connect the clipper to the AC mains supply without the
DC mains adapter connected.
• Avoidcontactwithmovingorhotclipperblades.Neverusetheclipperwithbladesthathavebroken
teeth.
• Unplug the appliance when not in use and allow cooling down before storing in a dry and safe place. To
disconnecttheappliance,switchoffandunplugfromthewallsocket.
• Never use any appliance or component of an appliance in any manner except for which it was
designed,donotmakealterationstoanyapplianceorcomponentwhichmayleadtopersonalor
environmental harm. Never use a defective appliance or component.
• Keep the appliance and electric cord away from sources of heat and from heat sensitive surfaces
(plastics, vinyl etc.)
• Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
Should the following situations occur, unplug and switch off immediately, and send for examination
or repair:
1. The blade, clipper, mains adapter or power cord is damaged
2. The clipper or the adapter is dropped into water.
The clipper and accessories must be checked regularly for damage.
If damage is detected, do not put the device into operation.
