Living Spaces Caira User manual

24 pcs.
Ø5/16-18 × 1-1/2"
Long Allen-Head
Bolt
24 pcs. J
Components packed with the Dining Table TOP
Made in Viet Nam
Page 1 of 2
Caira Rectangle
Dining Room
Assembly Instructions
21542 Double Pedestal Dining Table TOP
21543 Double Pedestal Dining Table BASE
Ø5/16" x 12 x 3mm
Spring Washer
Table Top
1 pc.A
Table Top Leaf
1 pc.B
Components and Hardware packed with the Dining Table BASE
Bridge Panel
2 pcs.C
Pedestal
Column
Bottom Frame
2 pcs.D 2 pcs.E
Ø5/16-18 × 3-1/4"
Long Allen-Head
Bolt
16 pcs.
H8 pcs. I
F
Ø5/16" x 19 x 2mm
Flat Washer
Be sure to check all packing material carefully for small parts, which may have come loose inside the carton during shipment.
Separate, count and check all parts against the Components and Hardware List above. Failure to use the correct length bolts in
the proper locations may result in an unsafe product and could also cause damage to the parts being assembled.
5mm Allen Wrench
1 pc.
G
ASSEMBLY STEPS:
Note: To prevent possible damage and scratches, this table should be assembled on a clean, soft surface such as a
blanket or carpet.
1. Attach the two Bridge Panels (C) to the top end of the Pedestal Columns using the 1-1/2" Long Allen-Head Bolts (F),
Spring Washers (H) and Flat Washers (I). Tighten with the Allen Wrench (J).
2. Turn the assembled Columns and Bridge Panels upside down and attach the Bottom Frames (E) to the Columns
using the 3-1/4" Long Bolts (G), and the same Washers as previous Step. Tighten with the Allen Wrench.
21742 Double Pedestal Dining Table TOP
21743 Double Pedestal Dining Table BASE
J
F
H
I
C
J
G
H
I
D
E
STEP 1
STEP 2

TABLE LOCK
Closed position TABLE LOCK
Open position
Adjustable
Leveler
TABLE LOCK
Open position TABLE LOCK
Closed position
Made in Viet Nam
Page 2 of 2
Caira Rectangle
Dining Room
Assembly Instructions
3. Carefully place the Table Top upside down.
4. Position both Columns and Base Frames on the bottom side of the Table Top and attach using the 1-1/2" long Bolts
and the same Washers as before. Tighten with the Allen Wrench.
5. Using two people, carefully lift the completed table and set upright.
6. To install or remove the Leaf, reach underneath the sides of the Table Top and unlock the catches. Pull the ends of
the Table Top apart, remove or add the leaf, slide the Table Top back together and re-lock the catches underneath.
Note: To prevent undue stress on the table and legs, if moving table, always use two people and carry the table from
one location to the other.
STEP 3 & 4
STEP 5 & 6
J
F
H
I
J
F
H
I
There are levelers installed underneath the columns which
can be used to compensate for uneven flooring, if needed.
Note: When attaching the two assembled
Table Bases to the bottom side of the Table
Top, orient so the ARROW label that is
affixed to the Bridge Panels are pointing
towards the end of the Table Top.