Living Spaces Halle C/E King User manual

CONGRATULATIONS ON YOUR NEW BED PURCHASE
~Warning：do not move bed after final assembly as it may result in damages to floor and/or bed.~
Hardware included in headboard carton to attach bed feet and center support system.
1 2 3
Step#1
Retrieve bed feet from carton fastened behind the headboard.
Attach bed feet (F) to the headboard using Wrench (I), Bolt (C) and Washer (E).
Step#2
Attach bed feet (F1) to the footboard using Wrench (I), Bolt (C) and Washer (E).
Step#3
Attach steel center support legs (J) to the Metal slat (G) using Wrench (I), Bolt (T) and
Washer (D).
A C D E F F G I J K T
Φ6*20 MM Φ8*50 MM Φ6 MM Φ8 MM H=5 CM H=5 CM Metal Slats Φ8 MM Center support legs
H=11CM
Φ8*80MM Φ6*25MM
8PCS 12PCS 16PCS 14PCS 2PCS 2PCS 4PCS 1PC 8PCS 2PCS 8PCS
Halle C/E King Assembly Instructions

CONGRATULATIONS ON YOUR NEW BED PURCHASE
~Warning：do not move bed after final assembly as it may result in damages to floor and/or bed.~
Hardware included in headboard carton to attach bed feet and center support system.
4 5
Step#4
Attach side rails to headboard using Wrench(I), Bolt (B) and Washer (E)(factory installed).
Step#5
Attach wings through headboard finger tight, using Wrench(I), Bolt (C) and Washer (E).
A C D E F F G I J K T
Φ6*20 MM Φ8*50 MM Φ6 MM Φ8 MM H=5 CM H=5 CM Metal Slats Φ8 MM Center support legs
H=11CM
Φ8*80MM Φ6*25MM
8PCS 12PCS 16PCS 14PCS 2PCS 2PCS 4PCS 1PC 8PCS 2PCS 8PCS
Halle C/E Kin
g
Assembl
y
Instructions
*Bolt B and Washer E
are factory installed*

CONGRATULATIONS ON YOUR NEW BED PURCHASE
~Warning：do not move bed after final assembly as it may result in damages to floor and/or bed.~
Hardware included in headboard carton to attach bed feet and center support system.
6 7
Step#6
Attach wings through side rail finger tight, using Wrench(I), Bolt (K) and Washer (E)
Tighten secure wings (6 bolts) with Allen wrench until snug.
Step#7
Move/place bed into final position in bedroom.
Attach steel slat support system to full length steel side support cleats(flat side facing up).
Verify the metal slats are installed properly into support cleats and center support legs are
perpendicular to the floor for full support.
A
C
D
E
F
F
G
I
J
K
T
Φ6*20 MM
Φ8*50 MM
Φ6 MM
Φ8 MM
H=5 CM
H=5 CM
Metal Slats
Φ8 MM
Center support legs
H=11CM
Φ8*80MM
Φ6*25MM
8PCS
12PCS
16PCS
14PCS
2PCS
2PCS
4PCS
1PC
8PCS
2PCS
8PCS
Halle C/E King Assembly Instructions