
User manual
3
Charging he earphones
Before the first use, char e the battery completely.
In order to char e the earphones, you need to use the char in box.
Place each earphone into a slot.
If the box is char ed, the earphones will immediately start char in , which is indicated by a red LED li ht on
the earphone.
If the char in box is not char ed, char e the box as per the instructions below.
When the earphones are fully char ed, the red LED li ht will turn off.
Charge he charging box
To char e the char in box, connect the small end of the Micro USB char in cable to the Micro USB port,
with the lar e USB port into computer’s USB port or an AC adaptor (not included).
A red LED li ht is flashin , when the char in box is fully char ed, the red li ht stays on.
Note :
The headsets will power off in 5 minutes if no connected with any wireless device.
Please put the earphones back to char in case after usin them.
Wireless connec ed
Take out the earphones from the char in case, power on the two earphones.
The two earphones pair automatically after the indicator li ht flash. Once finished one earphone indicator
flashes rapid and the other slowly.
Activate your pairin device’s Bluetooth ®. Search for “TES236” and select it to connect.
FAQ
1.L&R headse s can’ au o paired.
In off state, press L&R buttons and hold for 8s until blue & red li ht on, then loosen, and then powered on
a ain to pair
2. Phone can’ find he headse s or can’ connec wi h headse s
Put headsets back to char in case and then take out to connect with wireless device a ain, or cancel all
wireless connection in your phone and re-open Bluetooth to search and connect.
3. The headse s has in errup or disconnec ion from wireless device
1) The strai ht-line distance between headsets & wireless device is over 10M.
2) There is si nal blockin between headsets and wireless device.
4. Charging case can’ charge for headse s
1) Please clean the Char in interface for headsets and char in case
2) Please take out the headsets and put them back a ain
3) Please char e for the char in case