Instruction manual
WWW.LIVOO.FR
1) Insert the flexible tube into the canister air intake on the front of the vacuum cleaner. Push in until
you hear a "click", which ensures that the hose is securely in place. To remove, press the 2 latches
on either side and pull towards you to release.
2) Insert the hose handle into the telescopic tube.
3) You can adjust the height of the telescopic tube by pressing the black button on the tube to raise or
lower it.
4) Install the floor brush at the base of the telescopic tube.
This has 2 positions: for hard floors or carpets and rugs. Press the pedal on top of the brush to
change the position. The position with the brush is for carpets and rugs to allow for deep cleaning.
USE
1. Pull out the required length of cable. Never pull the cable past the red mark to avoid damage to the
automatic rewind system.
2. Connect the unit to the mains.
3. Turn on the unit by pressing the on/off button on the top of the product.
4. The variable power control allows you to adjust the suction power to the degree of dirt on your
floors.
The airflow can be adjusted with the hand control on the plastic handle (Schema.C) to prevent the
brush from sticking too much to the floor.
The crevice nozzle and brush attachments are especially recommended for grooves, hard-to-reach
corners and textile surfaces.
After use, switch off the appliance by pressing the on/off switch and unplug it.
Trigger the automatic cable rewind by pressing the rewind button.
DO NOT LEAVE THE CABLE OUT OF THE UNIT AFTER USE. Doing so may cause accidents and damage to
the unit.
Note: After use, do not pull on the cable to disconnect it. Do not roll or step on the cable.
MAINTENANCE AND CLEANING
Note: Always unplug the appliance before cleaning and wait for it to cool down completely.
•Clean the body of the appliance with a damp cloth and let it dry.
•Remove the dust container by pressing the dust container ejection button (1)
•Open the dust container, empty it and remove the filter by pulling it out (2) and (3). Wash it if
necessary
•Remove the HEPA filter and clean it by shaking/flapping it to remove the dust or by running it under
water if necessary.
CAUTION, make sure that the HEPA filter and the dust tank are dry before repositioning them in their
respective slots.