Possible Problem Easy Solution
Machine will not work when
switched “ON”.
The Safety Locking Arm may not be correctly engaged in the vertical
operating position with the locking arm located into the two grooves on
either side of the Juice Cover.
Motor appears to stall when
juicing
Wet pulp can build up under the cover if the juicing action is too
vigorous. Try slower juicing action by pushing the Food Pusher down
more slowly. Clean the lter bowl surround, the stainless steel lter and
the Juicer Cover. Select high speed instead of the low speed setting.
Excess pulp building up in
the Micro Mesh Filter Basket
Stop the juicing process. Remove the Juicer Cover, scrape off pulp.
Re-assemble and begin juicing again. Try alternating (soft and hard)
vegetable and fruit varieties.
Pulp too wet and reduced
extracted juice
Try a slower juicing action. Remove stainless steel Mesh Filter Basket
and thoroughly clean mesh walls with a ne brush. Rinse the lter
basket under hot water. If the ne mesh holes are blocked, soak the
basket in a solution of hot water with 10% lemon
juice to unblock the holes or wash in the dishwasher. This will remove
excess bre build up (from fruit or vegetables) which could be inhibiting
the juice ow.
Juice leaks between the rim
of the Juicer and Cover the
Filter
Try a slower juicing action by pushing the Food Pusher down more
slowly. Fruit and vegetables with a high water content (tomatoes and
watermelon) should be juiced on low speed.
Bowl Surround Juice sprays
out from spout
Try a slower juicing action by pushing the Food Pusher down more
slowly.
