Logic Controls LT9000 Series User manual

MECHANICAL
Weight1.20 lbs.
with adapter1.85 lbs.
Dimensions ( in inches )
Width8.90
Depth4.12
Height4.10
CONNECTOR PINOUT
DB9 F
1 Tied to pins 4 and 6
2 No connection
3 Data
4 Tied to pins 1 and 6
5 Ground
6 Tied to pins 1 and 4
7 Tied to pin 8
8 Tied to pin 7
9 No connection
ORDERING INFORMATION
GENERAL INFORMATION
1)Power adapter and 6 foot cable (with DB9M
and DB9F connectors) supplied.
2) Call for list of available emulations.
3)All control lines are terminated in the DB9
connector. For details see “Connector
Pinout” section above.
LT9000 TABLE-TOP DISPLAY SPECIFICATIONS
OPTICAL ( FLUORESCENT DISPLAY )
Number of rows 2
Digits per row 20
Digit Configuration 5x7 Dot Matrix
Digit Height0.37 in. (9.5mm)
Digit Width0.24 in. (6.2mm)
Digit Pitch0.30 in. (7.7mm)
Character Config. ASCII
Brightness900 cd/m2 Typical
Display ColorBlue-green
MTBF300,000 hours
ELECTRICAL
Power Adapter
Input Power120VAC, 60 HZ
Optional 220VAC, 50 HZ
Output Power7.5VAC, 1A
CABLING
Interface Cable
Computer sideDB9 female standard
DB25 female optional
DisplaysideDB9 male
ENVIRONMENTAL
Operating Temperature 0 to +50°C
Storage Temperature -20 to +70°C
Relative Humidity
Operating 85% max.
non-condensing
Non-operating 90% max.
non-condensing
Vibration (10 to 55 Hz.) 4G’s
Shock 40G’s
INTERFACE
Serial RS232C
Protocol
Baud Rate 600, 1200, 2400, 4800,
9600*,19,200
Data Bits 8
Parity NONE
Stop Bits 1
* Default preset at factory
LT9 _ _ _
POWER ADAPTER
0 = 120VAC
1 = 220VAC
SERIAL / PARALLEL INTERFACE
0 = SERIAL 9600 BAUD
1 = " 600 "
2 = " 1200 "
3 = " 2400 "
4 = " 4800 "
5 = " 19200 "
9 = PARALLEL INTERFACE
COMMAND SET
0 = LOGIC CONTROLS
1 = LOGIC CONTROLS with Pass-thru
2 = SPECIAL COMMAND SET 1 (Aedex)
3 = SPECIAL COMMAND SET 2 (Noritaki)
4 = SPECIAL COMMAND SET 3 (Epson)
5 = SPECIAL COMMAND SET 4 (UTC)
USB Optional Interface
USB INTERFACE
U
9 = OPOS
LOGIC CONTROLS, INC., NY, USA
An Innovative Manufacturer Since 1982
www.logiccontrols.com