Logosol 0458-395-0871 User manual

This manual describes installation of the electric motor
for the Logosol band sawmill.
Please see the user manual for your band sawmill for
information on assembly, settings and safety instructions.
Read through the user manual carefully and make sure
you understand its contents before using the saw.
12 KW ELECTRIC MOTOR
USER MANUAL
ORIGINAL USER MANUAL.
EN
SKU: 0458-395-0871
EN
REV: 1

2
1
Read through all the set-up instructions before starting to set up, then follow the
instructions step by step as you work.
Numbering for installation sequence
FINAL SAW HEAD ASSEMBLY,
12 KW ELECTRIC MOTOR
PACK SUPPLIED
8400-000-0080
8400-000-0082
12 kW electric motor, 400V
12 kW electric motor, 230V
After assembly, follow the instructions in the sawmill manual under the heading
Setup sequence to complete the setting before starting up the machine.

3
4 x – M10
8 x – M10
4 x – M10x40
2 x – M6x25
2 x – M6x30
2 x – 03-02182
1 x – 03-02080
1 x – 03-01997
M6x25 M6x30
2
1
12 KW ELECTRIC MOTOR
10mm
12mm
12mm
10mm
The electric motor comes with the hinge
switch connected. Assembly consists of
installing the motor on the motor shelf,
as well as mounting the pulley and drive
belt. The illustration shows the hole
pattern for mounting the 12 kW electric
motor. Follow the assembly instructions,
then run through the setup sequence for
the machine when assembly is complete.
INSTALLATION: ELECTRIC MOTOR
B1001, 12 kW electric motor
Top view:

4
3
4
5
6
2 x – M5x16
1 x – M5x50
2 x – M5x16
6 x – 6x16x1
3 x – M5
1 x – 9038-013-0003
1 x – 9038-013-0004
1 x
1 x – 03-01988
035 035
040
040
1 x – 9020-011-0091
Fit the drive belt over the
wheel and pulley.
Possibility of phase change
to change the direction
of rotation of the motor.

5
01
101 1
HOLD PRESS
12 KW ELECTRIC MOTOR
Turn the dead man’s switch to (1) to turn on the power supply to
the machine.
Hold down the dead man’s switch (button on the right) to start the
motor. Then press the start button (on the left). You can release the left
button when the motor has started. The motor will now run until the
dead man’s switch is released.
START THE MOTOR
TURN ON/OFF THE SWITCH BOX

6
Read through all the set-up instructions before starting to set up, then
follow the instructions step by step as you work.
It is important to adjust the saw head before starting to ensure satisfactory
sawing and the correct functioning of the sawmill. Follow the setup
sequence carefully! Certain adjustments affect other machine settings.
SETUP SEQUENCE
IMPORTANT!
Now you have finished installing the motor, go back to the manual
for your band sawmill and carry on with the setup sequence,
starting at the point as indicated in the instructions below.
Well done!

Fiskaregatan 2, SE-871 33 Härnösand, Sweden
0611-182 85 | [email protected] | www.logosol.se