Low Range Off-Road TDI-ELMG User manual

Suggested Tools:
•12 mm Socket
•Ratchet
•Extension
•Hacksaw
•Permanent Marker (White)
•Bench Vice
•File
CAUTION: Safety glasses should be
worn at all times when working with
vehicles and related tools and
equipment.
Toyota Electric E-Locker Motor Guard
(SKU# TDI-ELMG)
Installation Instructions

Step 2
Remove the E-Locker fasteners (two
nuts and one bolt) using a 12 mm
socket.
Step 1
Safely position the vehicle on a twin
post lift.
Note: We did this job on a twin post lift
but it could easily be done with a floor
jack and jack stands or it could be done
without lifting the vehicle at all.
Step 3
Remove the E-Locker cover by
removing the fasteners (two bolts) using
a 12 mm socket.
Bolt
Nuts
Bolts
E Locker
Cover

Step 4 Continued
Cover shown properly marked.
Step 4
Mark the cover as shown.
E Locker Cover Modification
Step 5
Secure the cover in a vice and cut
along the marks using a hacksaw (or cut
off wheel).
Step 5 Continued
E Locker cover properly cut.

Step 7
Reinstall the E-Locker cover and snug
the (2) attaching bolts.
Step 6
Smooth the rough edgers with a file.
Note: We also recommend painting the
exposed metal to reduce the risk of rust.
Step 8
Install the E-Locker guard and tighten
the (3) fasteners to 20 ft. Lbs.
Note: The lock washer that was fitted
behind the top nut will likely not fit and
should be let off.
E Locker Guard Installation
Leave lock
washer off

As always, If you experience any difficulty during the installation of this product
please contact Low Range Off-Road Technical Support at 801-805-6644 M-F
8am-5pm MST. Thank you for purchasing from Low Range Off-Road.
These instructions are designed as a general installation guide. Installation of many Low Range
Off-Road products require specialized skills such as metal fabrication, welding and mechanical
trouble shooting. If you have any questions or are unsure about how to proceed, please contact
our shop at 801-805-6644 or seek help from a competent fabricator. Using fabrication tools such
as welders, torches and grinders can cause serious bodily harm and death. Please operate
equipment carefully and observe proper safety procedures.
Rock crawling and off-road driving are inherently dangerous activities. Some modifications will
adversely affect the on-road handling characteristics of your vehicle. All products sold by Low
Range Off-Road are sold for off road use only. Any other use or application is the responsibility
of the purchaser and/or user. Some modifications and installation of certain aftermarket parts may
under certain circumstances void your original dealer warranty. Modification of your vehicle may
create dangerous conditions, which could cause roll-overs resulting in serious bodily injury or
death. Buyers and users of these products hereby expressly assume all risks associated with any
such modifications and use.
Revised 12/06/12© Copyright 2012 Low Range Off-Road, LC!!!!!! All Rights Reserved