Lowrance 000-15275-001 User manual

For product manuals, technical
specications, certicates and
declarations refer to the product
website:
www.lowrance.com
*988-12324-001*
3-IN-1 ACTIVE IMAGING
NOSE CONE TRANSDUCER
INSTALLATION GUIDE
The product complies with:
• CE under EMC Directive 2014/30/EU.
• Level 2 devices of the Radiocommunications (Electromagnetic Compatibility)
standard 2017.
The relevant Declaration of conformity is available at the following website:
• www.lowrance.com
!Warning: The user is cautioned that any changes or modications not
expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
Environmental
Operating temperature -15°C to +55° C (+5°F to +131°F)
Storage temperature -30°C to +70°C (-22°F to +158°F)
Sonar
Output Traditional, SideScan imaging,
DownScan imaging and
temperature
Frequency
Traditional 200 kHz / High Chirp
83 kHz / Medium Chirp
SideScan 455 kHz
800 kHz
Maximum depth*
Traditional 305 m (1000 ft) at 200 kHz / High Chirp and
83 kHz / Medium Chirp
DownScan 91 m (300 ft)
SideScan 91 m (300 ft) side range at 455 kHz
46 m (150 ft) side range at 800 kHz
* The maximum depth can vary depending on the output power of the
equipment the transducer is connected to.
Technical specications
Compliance

Mounting
1
2
3
4
B
1
2
C
A
4
3
D
E
Remove the existing nose cone transducer
In the example below, an HDI nose cone transducer is illustrated. The same
disassembly principles apply for other nose cones, whether they have a built-in
transducer or not.
Install the 3-IN-1 Active Imaging nose cone transducer
Before installing the nose cone transducer, check that the O-rings (1x A, 2x B and
1x C) are properly installed.
Tools required
• 8 mm hex key
Nose cone bolt (D) torque: 7.5 Nm (5.5 ft-lbf)
Nose cone cap (E) torque: 3.5 Nm (2.5 ft-lbf)
Parts included
• 1x 3-IN-1 Active Imaging nose cone transducer
• 4x O-rings (1x O-ring (A), 2x O-ring (B), 1x O-ring (C))