Loxit 500 Flip Top 8514 Hi-Lo User manual

1
8514 Hi-Lo®500 Flip Top™ Trolley
Assembly Instructions
1. Remove 1 end of gas strut.
Unpack the Hi-Lo®500 Flip Top™ Trolley.
Locate the gas strut to the side of the tilt mechanism. Using 2 spanners, remove
the m8 nyloc nut on the inside of the body and remove the end of the gas strut so
that it hangs from the tilt mechanism.
2. Remove retaining plate.
Unscrew the 2 fixings attaching the retaining plate to the flip top body, using the
allen key supplied. Remove the plate exposing the channel.
3. Channel exposed.
4. Remove mount and tilt mechanism.
Pull out the plunger on the side of the body, and lift the mount and tilt mechanism
out of the channel. (see step 5)

2
5. Body with mount and tilt mechanism removed.
6. Attach screen to mount.
Place the mount and tilt mechanism on the rear of the
screen and select the hole centres which position the
horizontal bar centrally to the screen.
Fix the mount and tilt mechanism to the screen.
7. Hang screen on trolley & re-attach retaining plate.
Using a minimum of 2 people depending on screen
weight, pull out the plunger as the screen bar is lowered
into the channel, ensuring the white nylon spacers are
positioned tightly to the ends of the channel.
Allow the plunger to locate into a stop position, relieving
the weight of the screen.
Re-attach the retaining plate over the channel.
8. Taking the weight of the screen, pull out the plunger and tilt the screen into the
horizontal position.
9. Re-attach gas strut.
Ensuring the screen is horizontal, place the washer on the gas strut thread and
then pass through the hole in the body. Tighten an m8 nyloc threaded nut on the
inside of the body, using 2 spanners.
10. Installation Complete.