Loxit 8510 User manual

Loxit Limited, First Avenue, Poynton Industrial Estate, Poynton, Cheshire, UK. SK12 1YJ
www.loxit.com ꞁ [email protected]m ꞁ [phone]
Manual Tilt, Electric Height Adjust Fliptop Trolley - 8510
-Max Capacity 25kg -Screens 32” - 42”
Safety instructions
Use the following safety guidelines to help protect your lift from potential damage and to
ensure your own personal safety.
Read all the installation instructions before testing or installing your lift.
The area below moving parts of the lift and screen MUST be kept clear of obstructions.
Keep the optional remote control out of reach of children.
To prevent bodily injury, keep hands and clothing away from the lift while the lift is in
operation.
Before installing the lift or working with its connections, unplug the lift from the mains
power supply socket
Do not place the lift in places subject to extreme temperatures for example near a
radiator, or heating vent.
The Electric lift must only be mounted in a dry area and it must ensured before use that
the lift is safe or protected from liquid contact or spillage.
Unplug the lift IMMEDIATELY in the following conditions:
-When the power cord or plug is damaged or frayed.
-If liquid has spilled into the lift.
-If the lift has been exposed to rain or water.
-If the lift exhibits a distinct change in performance, indicating a need for
servicing.
MANUFACTURERS who build this Lift into other products or use it with other products,
MUST make sure to prevent bodily injury. The MANUFACTURER is responsible to give
the end user proper warnings and instructions for use.
When adding a TV or any other equipment the party adding this TV or equipment is
responsible for stability and security.
The lift should only be used on a flat floor
WARNING ! THIS IS NOT A TOY !
WARNING ! CHILDREN SHOULD NOT OPERATE LIFT OR HAVE ACCESS TO THE
OPTIONAL REMOTE CONTROL !

Loxit Limited, First Avenue, Poynton Industrial Estate, Poynton, Cheshire, UK. SK12 1YJ
www.loxit.com ꞁ [email protected]m ꞁ [phone]
2. Hook the screen into the keyholes on the mount plate. With the screen hooked
in place, thread the remaining two bolts into the VESA pattern and then
tighten all four of the VESA bolts.
3. The screen may be powered using the IEC cable provided. Ensure any cables for
the screen cannot be trapped when operating the height adjustment or tilt
functions of the lift.
1. The casters on the base of the trolley
should be locked and the mount in the
vertical position before proceeding.
Thread two M8 bolts into the upper two
VESA holes on the back of the screen,
leave around 3mm threaded exposed.
Mounting the Screen

Loxit Limited, First Avenue, Poynton Industrial Estate, Poynton, Cheshire, UK. SK12 1YJ
www.loxit.com ꞁ [email protected]m ꞁ [phone]
1. To adjust the height of the screen, use the buttons
indicated on the back of the headbox, before
operating the electric height adjustment check
that there are no obstructions.
2. The screen be set in 5 different pre-set
positons, to adjust the angle of the screen
first loosen the thumb wheel a few turns.
3. With the plunger in position the thumb wheel should now be tightened to
prevent accidental movement of the tilt mechanism.
Operating the Trolley
4. Whilst holding the screen in one hand pull out the
plunger pin with the other hand and move the
screen into the desired position, when in position
release the plunger pin and allow it to snap into
place.