LP&No.1 LPSC-029 User manual

Vintage Turntable
Model: LPSC-029
Instruction Manual
Please read this manual carefully before use and keep it for future reference

Before Use:
1. Choose a safe location and avoid placing the unit in direct sunlight or near any heat source.
2. Avoid environments subject to vibration, excessive dust, cold or moisture.
3. Due to the risk of electrical shock, do not open the cabinet. Should a foreign object accidentally find its
way into the interior of the unit, contact your local dealer.
4. Do not attempt to clean the unit with chemical solvents as this might damage the finishing. A clean, dry
cloth is recommended for cleaning.
5. Keep this manual for future reference.
Turntable Parts:
1. 45 RPM Adapter Holder
2. Tone Arm
3. Lift Lever
4. 33/45/78 RPM Speed Selection Switch
5. Auto Stop Control Switch
6. Phono Stylus Cartridge
7. Turntable Platter
8. Turntable Shaft
9. Power ON/OFF Control and Volume Knob
10. Headphone Jack
11. DC IN Jack
12. RCA Output Jack
13. 3 .5mm LINE IN Jack

Package Included:
The package includes below main unit and accessories. If anything missing, please feel free to contact our
after-sale service team via email [e-mail]
1. LPSC-029 Vintage Turntable
2. 9V 0.6A Power Supply Adapter
3. User Manual
4. Warranty Card
5. 45 RPM Adaptor
Getting Started:
1. Firmly and securely insert the DC plug of the adaptor to the DC IN Jack on the side of the turntable.
2. Plug the adapter’s AC plugs into a power outlet.
Listening to A Record:
1. Lift the buckle on the front of the turntable and open the lid.
2. Turn the power & volume control knob clockwise.
3. Place a record on the turntable platter and select the desired speed (33/45/78) according to the record.
NOTE: when playing a 45 rpm record, use the included 45 rpm adapter located in the holder near the
tone arm.
4. Remove the white plastic transparent cover from the cartridge. Open the tone arm clip to release the tone
arm. Push the lift lever backward to raise the tone arm and gently move the tone arm to the desired
position over the record. The turntable will begin to spin when the arm is moved toward the record(when
Auto Stop is turned on.). Push the lift lever forward to lower the tone arm slowly onto the desired position
on the record to begin playing the record.
5. If the Auto Stop Control Switch is turned ON, the record will stop automatically when finished. If Auto Stop
Control Switch is turned OFF, the record will NOT stop automatically when finished.
Remark: AUTO STOP function applies to most 33RPM vinyl records. However, for very few
vinyl records, it will stop when it does not come to the end(in this case, turn the AUTO STOP switch to
OFF position and then it will continue playback), or it will not stop when it comes to the end when AUTO
STOP is ON.
LINE IN Function:
1. Stop the vinyl playing.
2. Connect your iPod, MP3 player, mobile phones etc. to the LINE IN port with a 3.5mm-3.5mm audio
cable(not included).
3. You can enjoy the music of iPod, MP3 player, mobile phones etc. at the turntable player.
Music Playback on Your Own Speaker System:
1. Connect your own speaker system to the RCA port with a RCA-3.5mm audio cable (not included).
2. You can enjoy the music of the vinyl records at your own speaker system.
Music Playback on Your Headphone:
1. Connect your headphone to the headphone port.
2. You can enjoy the music of the vinyl records via your headphone.

How to Replace the Turntable Stylus (Needle)
Removing the Stylus from the Cartridge
1. Place a screwdriver at the tip of the stylus and push downward as shown in direction “A”.
2. Remove the stylus by pulling the stylus forward and pushing downward.
Installing the Stylus
1. Hold the tip of the stylus and insert the stylus by pressing as shown in direction “B”.
2. Push the stylus upward as in direction "C" until the stylus locks into the tip position.
Tips to Better Turntable Performance:
1. When opening or closing the turntable cover, handle it gently, gripping it either at the
centre or at each side.
2. Do not touch the needle tip with your fingers; avoid bumping the needle
against the turntable platter or record edge.
3. Frequently clean the needle tip-use a soft brush in a back-to-front motion only.
4. If you must use a needle cleaning fluid, use very sparingly.
5. Gently wipe the dust cover and turntable housing with a soft cloth. Use only a small
amount of mild detergent to clean the turntable and dust cover.
6. Never apply harsh chemicals or solvents to any part of the turntable system.

There Are More Nice Turntable Accessories available at
Our Amazon Store
Vinyl Records Carrier---It can store up to 29 pcs vinyl records.