Lifesaving Systems Corp.
#F-750-406 OM (Rev A).doc Updated 2014-10-20
#406 Medevac II Litter
WARNING: THIS LI TTER SHOULD ONLY BE USED BY PERSONS WITH SUFFICI ENT
PROPER PATIENT HANDLING .
STOWING:
When litter is not in use the proper stowage procedures should be taken:
1. Secure restraint strapped across the litter with minimal slack, see Figure 1
2. Verify flotation is secured to the frame.
3. Disassemble litter by turning couplers counter-clock-wise, see figure 2
4. Stack the sections of the litters on top of each other, feet and leg section on the bottom.
5. If practical store to avoid prolong exposure to direct sunlight.
6. Recommended: Use #408 Litter Cover while stowed to protect from unnecessary and unintentional exposure and
damages, see Figure 2. Zipper should be fully closed during stowage.
INSPECTION
Every 30 days, and after each use, carefully inspect the following:
1. Frame assembly for broken welds, bends (deformation), corrosion and abrasion.
2. Check float covers, floats, the plastic net liner, hardware, and restraint straps for cuts, tears, abrasion and any
other visible damage. Repair or replace as required.
Remove Litter from service if inspection identifies any damage or abnormal conditions indicated above. Repair or
replace accordingly.
Figure 3: Sections stacked in stowed position.
Figure 4: Medevac IIA Litter in
Figure 2: Disassemble by turning couplers
Figure 1: Secured Restraint Straps and Flotation
