LUCCI 250910 User manual

Installation Instructions
1 | P a g e v 1 . 1 ( 0 8 / 2 0 2 0 )
BLOC AIR PURIFIER
SKU# 250910
Rated Voltage 5V DC 1A
Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all
instructions carefully before assembly, installation and use of the product. Please keep the instructions for future reference.
Warranty
•This product is covered by a 12-month warranty. Please retain the proof of purchase.
•Warranty will be void if there is any damage due to improper usage or modification to the product.
•Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void the
warranty.
Installation requirements
•Select a suitable location for the product;
- Ensure it is on a flat and stable surface.
- This product is suitable for indoor use only.
- Do not place flammable material near or over the product.
•Take care not to pull any electrical wires during unpacking as this may damage the connection.
•Lay out all the components on a smooth surface and make sure no components are missing before assembling.
If parts are missing, return the complete product to the place of purchase for inspection or replacement.
•Check whether the product has been damaged during transport. Do not operate/install any product which appears
damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.
Operation directions
Operation:
1. Connect the USB cable to the appropriate adaptor and the power input.
NOTE: Please ensure an appropriate power adaptor is used according to the rated input (5V DC, 1A) of this
product.
2. Touch the power button to turn the product ON/OFF. Green indicators will flash during operation.
Replacement of the filters:
The HEPA filter & the active carbon filter are required to be replaced in about every 6 - 8 months.
WARNING: Unplug the appliance from the mains power before performing the replacement of the filters.
1. Lift the tap of the back cover and remove it from the body.
2. Replace the HEPA filter & the active carbon filter.
3. Install the back cover to the body and ensure it is secured.
NOTE: There is a clean cotton included for aroma purpose. (The cotton can be found after removing the back
cover - Fig.1A). Add a couple drops of essential oil to the cotton if needed. Replace the cotton when necessary.

Installation Instructions
2 | P a g e v 1 . 1 ( 0 8 / 2 0 2 0 )
Safety tips
•Always ensure the power is OFF and the product has cooled down before performing any maintenance, cleaning to
the product.
•To avoid injury or damage to the product, ensure that the power lead is secure before connecting the power.
•WARNING: If unusual oscillating movement is observed, immediately stop using the product and contact the
manufacturer, its service agent or suitably qualified persons.
•This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
•Children should be supervised to ensure that they do not play with the appliance.
•The Negative-Ions generator contains hazardous high voltage which may cause electrical shock. DO NOT attempt
to disassemble the product in any circumstances.
•Do not block the air inlet / outlet. Do not try to insert finger or other foreign objects into the air inlet / outlet to prevent
physical damage.
•This product can not replace normal ventilation, regular vacuum cleaning and the use of range hood while cooking.
•Ensure the appliance is placed on a stable and horizontal surface.
•Ensure to keep at least 300mm of free space for the inlet & outlet of the product.
•Do not use the appliance near gas appliance, heating appliance or fireplaces.
•Do not spray insecticide, perfume or any other flammable spray around the product.
•The appliance does not remove carbon monoxide. Do not use as a safety ventilation device in the presence of
hazardous chemicals.
•Ensure the filters are properly installed after replacement. Only use the specified filters of this appliance.
•Ensure that the product does not come in contact with corrosive chemicals/solvents or abrasive cleaners etc.
•To clean, wipe with a damp clean cloth. Never soak the product with water.
Specifications
SKU # 250910
Model # HSD6045A
Colour White
Rated input 5V DC, 1A (USB Cable included)
Recommend area 8 – 15 m
2
Filter / Features Active carbon filter + HEPA filter / Negative-Ions generator
Weight 0.5kg
Dimensions H:147mm L:164mm W:100mm
Fig.1
Fig.1A