Lunasea LLB-45RE-91-K1 Instruction manual

REV-1
Wiring Diagram
Operation
After installing receiver and attaching to power and lights you must pair your receiver
with the remote.
1.With power on momentarily press the learn button on the receiver, then touch on
remote.The light will blink once to signify that your receiver and remote are paired.
2.You can now power and dim your lights.To power on or off, simply press power button
on top.This works as a master switch and all lights in all zones are controlled. To work
lights in 1 zone. Select that zone on the remote. Quick touch to turn off or on. Long
touch to control dimming.
To delete memory on receiver LLB-45RR-91-00
Long press the“Learning Button”for 5 seconds - The receiver will delete memory of ALL
paired remotes
Dimensions
Safety Information:
1.) The product should be installed by a qualified person.
2.) IP20 – Do not install in direct sun. For outdoor installation, mount in a waterproof enclosure.
3.) Always be sure to mount this unit in an area with proper ventilation to avoid overheating.
4.) Install with power rated for this product.
5.) Never connect any cables while power is on and always assure correct connections to avoid
short circuits before switching on.
6.) Ensure all wires are secured tightly in the connector.
7.) For updated information, please consult your Lunasea Lighting Supplier.