Luxafor Cube User manual

Luxafor Cube
User Manual

Luxafor Cube Package Contents
1x Luxafor Cube
1x USB Charging Cable
1x Magnet with
double-sided tape
Product Specifications
Dimensions: 52 x 52 x 27 mm
(2.05 x 2.05 x 1.06")
Weight: 56g
Light: 6 x RGB LEDs
Consumption: Rated power up to 26 mA
Charging: With a standard micro USB data cable
Built-in 1200mAh battery
Working time: 46 h - 90 hnon-stop use.1
Contact us at [e-mail] or call [phone]
1

Charging Instructions
1. Prior to use, charge the Cube unit by connecting the included charging cable into a USB
power outlet such as a USB charger and plug the other end into the Cubes’ micro USB
charging port.
2. The Luxafor Cube will turn on immediately when the charging has begun.2
3. You can use the Luxafor Cube unit safely during the charging process - it will operate
normally.
Getting Started
1. When the Cube has been fully charged, it’s ready to use.
2. Remove the plastic from the double-sided tape that is on the magnet and attach the
magnet to the surface on which you would like to place the Luxafor Cube, or place it on
the surface of your liking, such as a desk.
3. Short press the button at the back of the Luxafor Cube unit to turn on the device.
4. Change the colors by placing the Switch Cube sideways, as shown below:
5. Enjoy!
Contact us at [e-mail] or call [phone]
2

Turning the Cube Unit Off
To turn the Luxafor Cube off, press and hold the button at the back. Release when Purple
color is indicated.
Sleep Mode
If you place the Cube in a face-up position, it is not turned off. It instead enters “Sleep
Mode”, where it is ready to be used as soon as it is positioned upright again.
Eco Mode
To use Eco Mode, press and hold the button at the back of the Luxafor Cube. Release
when Orange color is indicated.
The same applies to exiting the Eco Mode.
When Eco mode is enabled the Cube will indicate the colors in pulsating (slowly blinking)
fashion. When Eco mode is not enabled, the Cube will indicate in solid colors.
Reading the Battery Levels on the Cube
Place the Luxafor Cube in a face-up position to check the battery levels. The Cube will
indicate Cyan Blue color, and the total amount of LEDs shining will indicate approximate
power left on the Switch Cube device. LEDs are placed as shown in the following scheme:
●The battery is fully charged when all 6 LEDs
are shining.
●The power level indicators will start to
drop, starting from LED No. 1 going clockwise.
●Consequently, when the battery level is
critically low, it will indicate only the LED No. 6
shining. Immediate charging is needed.
Contact us at [e-mail] or call [phone]
3

Understanding the Color Indicators
●Purple upon long-pressing the button: You can now release the button and the
Switch Cube will turn off.
●Orange upon long-pressing the button: You can now release the button and the Eco
Mode will be turned on/ off.
Additional Remarks
1Working time: average 66 h: 46 h on continuous use for yellow color (58 h in Eco mode),
73 h on continuous use in green, red, or blue colors (90 h in Eco mode).
2If the battery level for the Switch Cube is extremely low, it is possible that when starting
the charging process, the device will not turn on immediately. It will charge for a short
period of time and once it has enough power, will turn on and operate normally.
Contact us at [e-mail] or call [phone]
4