LV Furniture B6582-K-HB User manual

ASSEMBLY INSTRUCTIONS
MODEL:B6582-K-HB, B6582-K-FBD,B6582-KQ-RAIL
NOTE:MUST TIGHTEN SCREW PERIODICALLY.WITH USE SCREWS WILL
BECOME LOOSE CHECK THIGHT OF ALL SREWS EVERY 6-8 WEEKS.
CLEANING INSTRUCTION
After assembled,clean & polish the complete parts if necessary with soft clotch ang industrial recognized furniture polish. MADE IN MALAYSIA
Thank you for purchasing this quality product.Be sure to check all packing material carefully for small parts which
may have come loose inside the carton during shipment.Identify and count all parts and compare with hardware
list as below: STEP 1
STEP 2
A
B
BC
K
L
B
D
D
Affix the Leg Support (D) to Foot
Board (B) as shown. Loosen or
tighten Leg Support (D) as necessary
to level the bed.
D
C
C
B
Attach and tighten the FB leg
(C) to the Foot Board (B), insert
JCBC (M6) With Washer (K) as
shown.
ITEM DRAWING DESCRIPTION QTY
1
AHEAD
BOARD
(BOX 1) BOX OF HEAD BOARD
ITEM DRAWING DESCRIPTION DIMENSION
4 X 32MM
IC.S.K SCREW
(M4)
QTY
6
(BOX 2) BOX OF FOOT BOARD (HARDWARE LIST)
ITEM DRAWING DESCRIPTION QTY
1
BFOOT
BOARD
(BOX 2) BOX OF FOOT BOARD
C
D
FB
LEG 2
2
LEG SUPPORT FOR
FB
ITEM DRAWING DESCRIPTION QTY
2
HSIDE RAIL (L&R)
(BOX 3) BOX OF SIDE RAILS
E11
SLAT
F1
CENTER SLAT
G6
SLATS SUPPORT
6 x P1.0 x 100MM
KJCBC (M6)
WITH WASHER
L
2
1
ALLEN KEY M4 4 x 65MM
H
COMPLETED
ASSEMBLY
Page 1 of 2
6 x P1.0 x 35MM
JCBC (M6)
WITH WASHER 3
J
Screw Driver is not
included
M1
ALLEN KEY M5 5 x 65MM

NOTE:MUST TIGHTEN SCREW PERIODICALLY.WITH USE SCREWS WILL
BECOME LOOSE CHECK THIGHT OF ALL SREWS EVERY 6-8 WEEKS.
CLEANING INSTRUCTION
After assembled,clean & polish the complete parts if necessary with soft clotch ang industrial recognized furniture polish. MADE IN MALAYSIA
A
B
H
E
G
F
12
3
Important !!
LEVEL THE SIDE RAIL BY COVERING
WITH A SOFT CLOTH AND TAPPING
WITH A HAMMER.
Press laterally into the
groove and drop
down.
I
H
E
3STEP 3
Fix both side rails to the
Headboard and Footboard
as below
STEP 5 :Finally, secure the
Wooden Slat in place with the
32mm screws (I) with screw driver
(*not include)
STEP 4 :Spread out all the Slat (E) on the
Center Slat (F). Further secure JCBC screw
with washer (J) to middle pre-drilled slat to
the Center Slat (F). Fix the Support
Leg (G) into the Slat Support (F)
as show and adjust it to
the height required.
4
J
FE
G
5
Page 2 of 2
M