LZHZXY HE-150 User manual

0
HE-150
Commercial Air Purifier
OWNER’S MANUAL
Please read all of the information provided in this owner’s
manual before operating your new Commercial Air purifier.

1
CAUTION
RISK OF ELECTRICAL
SHOCK DO NOT OPEN
ATTENTION
CAUTION: TO REDUCE THE RISK OF ELECTRICAL SHOCK, DO
NOT REMOVE COVER. NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVCE PERSONNEL.
This “bolt of lightning” indicates that uninsulated material
within your unit may cause an electrical shock. For the
safety of everyone, do not remove product covering.

2
Read ALL instructions carefully before using this product.

3
Model: HE-150
Rated Voltage: Europe AC 220-240V/50-60Hz
USA/Japan AC 100-120V/50-60Hz
Power Consumption: 55 W
Ceramic Plate Size(1plate): 90X50MM
Air Volume: Max 80 CFM(2.24 M3/min)
Active Oxygen(on) ：3.5 g/h
Sound Level(DB): 35 Db
Product size(mm): W175xH150xD205MM
Weight: 2.0Kgs(4.4Lbs)

4
Operating the Commercial Purifier
(Front View)
Timer Control Knob Turn clockwise to set the
timer for timed operation up
to two hours.
Indicator Light Illuminates when unit is in
operation.

5
(Back View)
Fuse Holder
Houses removable fuse.
(Spare fuse included, 1 amp, 0.79
inch in length)
Power Cord
220~240 Volt grounded cord (unless
otherwise.

6
The Commercial Air Purifier is designed to remove odors in
unoccupied spaces. The unit has a timer that will enable it to run for
a maximum duration of 2 hours. The timer will then shut the
commercial air purifier off. You should allow 40 minutes before
returning to the treated area.
To operate the Commercial Air Purifier:
Close off the desired area to be treated.
Remove all occupants and pets.
Position the unit as close as possible to the odor source.
In such environments as motels that have individual heating
and cooling systems, turn the fan on and set on re-circulate.
Set timer to desired time and leave the room.
Allow 40 minutes before re-entering the treated space.
Return to space & ventilation area.

7
When the air purifier no longer produces enough ozone to be
effective, the ozone plate should be replaced.(Usually it should be
replaced after working 5000 hours)
How to replace a plate:
1) Turn the unit off and unplug from outlet.
2) Use a screw driver to unfasten cover screw and remove
cover.
3) Pull ceramic plate out of ozone generator module.
4) Install ceramic plate as shown in left figure (be careful not to
drop the plate).

8
If you suspect a problem with your unit check the following:
1) Unit is plugged in properly.
2) It’s important that the Commercial Air purifier be properly
grounded to avoid potential shock.
3) Fuse is installed properly and in good condition. To replace
fuse, pull out the plastic fuse holder, remove old fuse and
insert new fuse. Replacement fuse must be 1 amp (0.79
inch). Refer to picture as follows:

9
The commercial air purifier comes with a 3 Year Limited Warranty.