
17
Temperature display: SUHVV5(6(7RQ35&'UHDGWKHFXUUHQWWHPSHUDWXUHRQWKHVFUHHQ
Heater Button: 3UHVV+($7(5EXWWRQWRVWDUWRUVWRSKHDWLQJ
7KHILOWHUZLOODXWRPDWLFDOO\EHUXQQLQJIRUVHFRQGVWRWHVWWKHZRUNLQJFRQGLWLRQRQFH+($7(5
function is started. If there is no abnormality, the heater will keep working until the water temperature
reaches the set value. When water temp goes below the set temp, the heater will restart to heat the
ZDWHUDXWRPDWLFDOO\7KHFRQVWDQWOLJKWLQJ+($7(5LFRQPHDQVWKHKHDWLQJV\VWHPLVRQZRUNLQJ
VWDWXV7KHIODVKOLJKWLQJ+($7(5LFRQPHDQVWKHKHDWLQJV\VWHPLVLQLWLDWLQJRURQLQVXODWLRQPRGH
Filter Button: 3UHVV),/7(5EXWWRQWRWXUQWKHIXQFWLRQRQRII7KH),/7(5LFRQVKRXOGEH
constantly lighting when the function is activated.
NOTE: Filtration cannot be turned off when Heating is activated (Whether the heater is running or at
rest). When Heating function is turned off, filtration will stop after 30 seconds. Filtration function can
then be activated separately.
NOTE: The auto-filtration system is automatically activated every 4 hours.
Bubble Button:&DQDGMXVWDPRQJOHYHOVRIEXEEOLQJSRZHU7KHGHIDXOWEXEEOLQJPDVVDJH
power is at level 2 (500W). Press the BUBBLE button again, switching to level 3 (720W). Press again
to enable level 1 (300W). To shut down the function, press the BUBBLE button for 3 seconds.
NOTE: The bubbling massage function will be shut down automatically after every 20 minutes
operation for safety concern. It cannot be operated within 10 minutes after shutting down.
Adjustment Buttons: 3UHVV83RU'2:1EXWWRQWKHVFUHHQIODVKHVVHWWLQJWHPSHUDWXUH5HVHW
the temperature within 3 seconds. Otherwise the temperature setting mode will end automatically. If
the other button is pressed during the setting , the setting will also stop. The current temperature
shown on the screen is confirmed.
NOTE: 'HIDXOWVHWWLQJWHPSHUDWXUHLV&7HPSHUDWXUHVHWWLQJUDQJH&
Controller Locking: Press UP and DOWN button at the same time for 3 seconds, the buzzer will
ring 3 times, meaning that the controller is locked. In this mode, the function will not be turned on if
the button is pressed. Press UP and DOWN button at the same time again for 3 seconds to unlock
the controller.
Timer Button:3UHVVWKH7,0(5EXWWRQWRHQWHUWKHLQWHOOLJHQWSUHVHWWLQJPRGH%\SUHVVLQJ83
DQG'2:1EXWWRQ\RXFDQVHWDQGVWDUWKHDWLQJDXWRPDWLFDOO\ZLWKLQXSWRKRXUV7KH7,0(5
setting is confirmed if no further operation in more than 3 secondsRUSUHVV7,0(5EXWWRQDJDLQ7KH
heater will start working after current setting hours. The setting hour can also be changed by entering
WKHSUHVHWWLQJPRGHDJDLQ7KH7,0(5LFRQVKRXOGEHFRQVWDQWO\OLJKWLQJZKHQDFWLYDWHG
Cancel: 3UHVVWKH7,0(5EXWWRQIRUseconds to cancel the pre-setting.
NOTE: The pre-setting function cannot be turned on during heating process. The pre-setting mode
will also end once the heating function is on or after the spa is reboot.
FILTER
HEATER
BUBBLE
TIMER