MAcarbon Ferrari 360 Map Carbon Light User manual

Ferrari 360 Map Carbon Light Installation Instructions
Tools Required
4MM Allen Wrench
Small Philips Screw Driver
MAcarbon Chisel Install Tool
Detail Cloth
Detail Spray
Installation Steps
Step Instructions Photo
1. Pop the map light out from the housing by inserting
the chisel tool into the gap on the light's right side.
2. Support the map light and let it hang.

Step Instructions Photo
3. Locate the four (!) Allen screws that mold the map
light housing in the roof.
4. Unscrew the housing from the roof.
5. Lower the housing. Gently pull the wiring from the
headliner.
6. Undo the electrical connector.

Step Instructions Photo
7. Place the map light on the workbench, carefully
remove the two Phillips head screws which hold the
clock in place.
8. Disconnect the clock.
9. Take this opportunity to clean all components of dust
and grime.
10. Install the clock and light in the CF housing. Be sure
to route the wires correctly.

Step Instructions Photo
11. Screw the unit into the ceiling.
12. Push the light into place
13. Admire your work!