SERVICE
Jill Jill i IIIIIIIIliiillli Jill II illlli E Illll Z IIIIIIIIIIIIIIII i IIIIIlillli IIIIIIIIii I illlli ill illiLI]JJ[_
BEFORE
CALLINGA SERVICETECHNICIAN,
PROBLEM
1. Surface burnerfails to light
2. Burnerflame uneven
3. Surface burnerflame
* lifts off port
* yellow in color , ,,,,,,,,,, ,,,, ,,,,,,,,,,
4. Ovenburnerfails to light
5: Oventemperatureinaccurate
* food takes too long or cooks
too fast
.pale browning
*food over-doneon outsideand
under-donein center
* over browning
6. Clockandlor light does not work
7.;Fplusa numberappearsinthedis-
play. (Example F 1) Continuous
:beepssound.
SERVICE
Do not attempt to service the
appliance yourself unless directed to
do so in this book. Contact the dealer
who sold you the appliance for
service.
CHECKTHEFOLLOWING:
CAUSE
IIIII IIIIIIIIIIIIlil IIIIIU li IIIIIIII
a. power supply not connected
(Pilotlessignition)
b. cloggedburnerport(s)
IIIII mmmmmmm • m
a. cloggedburnerport(s)
b. burner not properlypositioned
HOWTOOBTAINSERVICE
When your range requires service or
replacement parts, contact your
Dealer or Authorized Service Agency.
Consult the Yellow Pages in your
telephone directory under ranges for
the service source nearest you. Be
sure to include your name, address,
and phone number, along with the
model and serial numbers of the
appliance. (See inside cover for
location of your model and serial
numbers).
a. air/gas mixture not proper
a. power supply not connected
(Pilotlessign!tion)
b. electronicclock incorrectlyset
a. oven not preheated
b. incorrectrack position
c. incorrectuse of foil
d. oven bottomincorrectlyreplaced
e. oven thermostatsensingdevice
out of holdingclip(s)
a. power supply not connected
b. burnedout light bulb
c. defectiveswitch, starter or ballast
d. defectiveclock or loose wiring
CORRECTION
J IIIIII IIIII I I IIIIIIIIII
a. connectpower, check circuit
breakeror fuse box
b. clean ports with straight pin
a. clean ports with straight pin
b. see page 6 to correctlyreplace
burner
,,,,,,,,,,,,,,, ......................................................
a. call servicemanto adjust burner
primary air
iiii
P
a. connectpower, checkcircuit
breakeror fuse box
b. see page 5
a. preheatoven 10 minutes
b. see page 8
c. see page 9
d. replaceoven bottomcorrectly
e. reinsert sensingdevice securely
into clip(s)
a. connectpowersupply,check
circuit breakeror fuse box
b. replace light bulb
c. call servicemanto check
d. call servicemanto check
,,,,,,,,,,,,,,, , ,,,,,,,,,,,,,,,,,
Theseare calledFAULTCODES.If a fault code appears in the display and a €o_om--
tinuousbeepsounds,pressthe STOP/CLEARbutton.If the fault code reappears,
disconnectpowerto the range and call the service agency.
............................................................. mmmmm, |l mmmll
tf you are not satisfied with the local
response to your service require-
ments, call or write MAYCOR Parts
and Service Co., P. 0. Box 2370,
Cleveland, TN 37311, (615) 472-3333.
Include or have available the com-
plete model and serial numbers of the
appliance, the name and address of
the dealer from whom you purchased
the appliance, the date of purchase
and details concerning your problem.
If you did not receive satisfactory
service through your service agency
or Maycor you may contact the Major
Appliance Consumer Action Panel by
letter including your name, address,
and telephone number, as well as the
model and serial numbers of the
appliance. 16
.J.
Major Appliance ConsumerAction Panel
20 North Wacker Drive
Chicago, tL 60606
[
MACAP (Major Appliance Consumer
Action Panel) is an independent
agency sponsored by three trade
associations as a court of appeals on
consumer complaints which have not
been resolved satisfactorily within a
reasonable period of time.