MAGNITUDE LIGHTING E Series User manual

INSTALLATION GUIDE
E-SERIES
120VAC / 24VDC
Magnitude, Inc. Page 1of 2
14711 Bentley Circle. Tustin, CA 92780 www.MagnitudeInc.com [email protected] DOC-GU-400048 Rev. 1
General
This driver is to be installed in accordance with Article 450 of the
National Electric Code. The driver must be installed in a well-ventilated
area free from explosive gases and vapors. Proper operation requires
for free flow of air. This driver should only be installed by a qualied
electrician.
Precautions Before Installing
Check the label and ensure the driver has the proper input voltage and
wattage for the job. Check the wire markings to ensure they match the
wiring diagram on this installation guide.
Quick Specs
Input Voltage 120V AC
Output Voltage 24V DC
Max. Ambient Temp. -200C to 700C (-4°F - 158°F)
Enclosure Nema 3R - Outdoor Use
Min. Installation Space
Between Drivers 5” Inch
Mounting
Select a suitable location capable of supporting the weight of the
driver. Use the two key holes in the wire housing and third hold on the
flange when mounting. It is recommended that the driver be mounted
vertically with the wiring compartment pointing down. Recommended
spacing between drivers is 5”.
5” Min.
Spacing
Wiring
Compartment
Input Connections / Grounding
Remove wire compartment cover plate.
1
Remove knockouts and install wire strain reliefs.
E-SERIES LISTED
FOR MODELS
E20L24DC, E40L24DC, E60L24DC, E75L24DC, E96L24DC
Mounting
Holes

INSTALLATION GUIDE
E-SERIES
120VAC / 24VDC
Magnitude, Inc. Page 2of 2
14711 Bentley Circle. Tustin, CA 92780 www.MagnitudeInc.com [email protected] DOC-GU-400048 Rev. 1
Wiring Diagram
INPUT
120V AC 60Hz Dimmer
(Optional)
Green Wire
Ground
Red Wire
Blue Wire
Input Wire (black)
Input Wire (white)
OUTPUT
12V DC
+
-
We Drive Light
The contents of this document are subject to change without notice
14711 Bentley Circle, Tustin, CA 92780 Tel: [phone] Fax: [phone] www.magnitudeinc.com rev002
MAGNITUDE
LIGHTING
Wiring Diagram
INPUT
120V AC 60Hz Dimmer
(Optional)
Green Wire
Ground
Red Wire
Blue Wire
Input Wire (black)
Input Wire (white)
OUTPUT
12V DC
+
-
We Drive Light
The contents of this document are subject to change without notice
14711 Bentley Circle, Tustin, CA 92780 Tel: [phone] Fax: [phone] www.magnitudeinc.com rev002
MAGNITUDE
LIGHTING
Wiring Diagram
INPUT
120V AC 60Hz
Dimmer
(Optional)
Green Wire
Ground
Red Wire
Blue Wire
Input Wire (black)
Input Wire (white)
OUTPUT
12V DC
+
-
We Drive Light
The contents of this document are subject to change without notice
14711 Bentley Circle, Tustin, CA 92780 Tel: [phone] Fax: [phone] www.magnitudeinc.com rev002
MAGNITUDE
LIGHTING
Wiring Diagram
INPUT
120V AC 60Hz Dimmer
(Optional)
Green Wire
Ground
Red Wire
Blue Wire
Input Wire (black)
Input Wire (white)
OUTPUT
12V DC
+
-
We Drive Light
The contents of this document are subject to change without notice
14711 Bentley Circle, Tustin, CA 92780 Tel: [phone] Fax: [phone] www.magnitudeinc.com rev002
MAGNITUDE
LIGHTING
Wiring Diagram
Do not install PWM low voltage
controllers on the output without
consulting with Magnitude Inc.
Dimming
Dimmable with any standard MLV / Incandescent
TRIAC (Leading edge) dimmer switch. Dimmer
switch is to be installed on the input (120VAC side)
of the driver. For smooth dimming, 8W minimum
load is required. Please visit our website for a full
dimmer compatibility list www.magnitudeinc.com
With power turned off, route the
input wires through a strain relief
and connect one wire to black
and one wire to white. for all wire
connections use only UL listed
wire nuts and connectors of
suitable size and type. Connect
the ground wire to the transformer
green wire.
23 4
OutputInput
Wire Nuts
(By others)
Output Connections
Bring the wires of the light xture through the other clamp
connector and connect them to the driver wires - positive
to the red (+ ) wire and negative to purple ( - ) wire.
Measuring the output voltage without a load will result
readings greater than the nominal voltage.
The transformer case MUST be
grounded in accordance with the N.E.C
Wire nuts or wago connectors by others
OUTPUT
24V DC
Black
White
Green
Blue
Red
Black
White
Green
Blue
Red
Strain Reliefs
Mounting Holes