Magnolia Home JOANNA GAINES MILLER 15216011 User manual

Read instructions carefully prior to assembly.
Thank you for purchasing this quality product. Check carefully for small parts which may come loose during
shipment. Remove all components from pack and place top down on soft surface such as carpet or cloth to
prevent scratching the finish. Identify and count all parts as specified below.
It is recommended to use two or more persons during the assembly process.
Page: 1/3
PARTS LIST:
1 Pc
Top
Qty
Description
No. Sketch
1
4 Pcs
4 Pcs
Leg
2
Stretcher
3
HARDWARE LIST:
No. Description
A8 Pcs
B
C
Ø5/16*19 Flat Washer
Ø5/16*13 Spring Washer
4mm Allen Key 1 Pc
D
Ø5/16*20 Allen Bolt
EØ4*38 Screw
ASSEMBLY INSTRUCTIONS
GROUP NO.: 15000002 MODERN OCCASIONAL
ITEM NO.: 15216011 TABLE,COFFEE,ROUND-MILLER
8 Pcs
8 Pcs
8 Pcs
LOWER HOLE
LOWER HOLE
LOWER HOLE
LOWER HOLE
HIGHER HOLE
HIGHER HOLE
HIGHER HOLE HIGHER HOLE
HIGHER HOLE
LOWER HOLE
Left side Right side
2
1
NOTE: SEE THE LOWER HOLE IS LEFT SIDE, THE HIGHER HOLE IS RIGHT SIDE.
Step 1: Align the Leg (2) to make sure all the legs are the same direction as picture shown
Made in Vietnam

Read instructions carefully prior to assembly.
Thank you for purchasing this quality product. Check carefully for small parts which may come loose during
shipment. Remove all components from pack and place top down on soft surface such as carpet or cloth to
prevent scratching the finish. Identify and count all parts as specified below.
It is recommended to use two or more persons during the assembly process.
Page: 2/3
Made in Vietnam
ASSEMBLY INSTRUCTIONS
GROUP NO.: 15000002 MODERN OCCASIONAL
ITEM NO.: 15216011 TABLE,COFFEE,ROUND-MILLER
D
C
B
A
DIRECTION PRE-DRILL HOLE
DIRECTION PRE-DRILL HOLE
2
1
Step 2: Attach the Leg (2) to the Top (1) by using Flat washer (A), Spring washer (B) , Allen Bolt (C), tighten bolts
by turning Allen key (D) as clockwise.
NOTE : DO NOT FULLY TIGHTEN THE BOLT AT THIS STEP, JUST KEEP THE LEG STAND ON THE TABLE TOP
Step 3: Align the Stretcher to pre-drill holes on leg .
NOTE : DIRECTION PRE-DRILL HOLE TO ATTACH SCREW ON EACH STRETCHER ARE NOT SAME DIRECTION
AFTER ASSEMBLING THE LEG

E
E
Read instructions carefully prior to assembly.
Thank you for purchasing this quality product. Check carefully for small parts which may come loose during
shipment. Remove all components from pack and place top down on soft surface such as carpet or cloth to
prevent scratching the finish. Identify and count all parts as specified below.
It is recommended to use two or more persons during the assembly process.
Page: 3/3
Made in Vietnam
ASSEMBLY INSTRUCTIONS
GROUP NO.: 15000002 MODERN OCCASIONAL
ITEM NO.: 15216011 TABLE,COFFEE,ROUND-MILLER
Step 5: Turn up right table.Assembly in now completed.
Step 4: Attach each the Stretcher (3) to the Leg (2) by using Screw (E) with Screw-Driver (not provide).
NOTE : FULLY TIGHTEN THE ALL BOLT AND SCREWS AT THIS STEP.