Maico EZQ 40/4 B User manual

INSTALLATION INSTRUCTIONS
EZQ 40/4 B
Version: 2018-01-25 - MAICO VENTILATOREN, www.maico-fans.com - We are not responsible for mistakes or printing errors and retain the
right to make technical modifications without giving prior notice Page 1
Air extraction from server / compressor / transformer rooms
■The EZQ/EZS or DZQ/DZS wall-mounted fans can be used to extract air and therefore remove high thermal loads from
closed rooms.
■A thermostat (e.g. TH 16) permanently measures the room temperature.
■If the setpoint temperature is exceeded, firstly the exhaust fan (e.g. EZQ/EZS or DZQ/DZS) switches on and secondly the
shutter, e.g. MK opens.
■The fan extracts the warm exhaust air from near the ceiling.
■Cool supply air flows to ground level through the open shutters.
■For optimum operation with minimum flow resistance, the free cross-section area for supply air should be twice that for ex-
haust air.
■A supply air filter (e.g. ZFF) collects particles of dust and dirt from the supply air to protect sensitive electric or electronic
systems in the room from damage.
1MK, BK shutter
2ZFF air filter
3TH 10, TH 16 thermostat
4Systems with high thermal load
5EZQ/EZS or DZQ/DZS fan
6RS external shutter
Air extraction in storage rooms
With cross-ventilation, the supply air flows through the whole room before being extracted again.
In most cases the supply air opening (e.g. MLA or MLZ external grille) should be fitted near the ground. However extract the
exhaust air from near the ceiling using a wall-mounted fan (e.g. EZQ or DZQ).

INSTALLATION INSTRUCTIONS
EZQ 40/4 B
Version: 2018-01-25 - MAICO VENTILATOREN, www.maico-fans.com - We are not responsible for mistakes or printing errors and retain the
right to make technical modifications without giving prior notice Page 2
This setup does not apply if gases which are heavier than air (e.g. CO2 or most combustible gases and vapours from a po-
tentially explosive atmosphere) are to be extracted. Then the supply air should be fitted under the ceiling and the exhaust air
extracted from ground level.
1MLA or MLZ external grille
2EZQ or DZQ fan
Supply and exhaust air for sensitive systems where the outside air is polluted
■Reliable ventilation and air extraction in systems with tougher ventilation requirements (e.g. electric or electronic switching
systems) can be provided with a combination of EZF/DZF fans for wall installation and EZQ/DZQ wall-mounted fans.
■EZF/DZF fans for wall installation and a RS shutter provide the supply air. Fitting the ZFF air filter is the recommended ap-
proach if the outside air is very polluted (e.g. building site, on roads or railway tracks).
■An EZQ/DZQ wall-mounted fan with corresponding AS shutter blows the exhaust air out.

INSTALLATION INSTRUCTIONS
EZQ 40/4 B
Version: 2018-01-25 - MAICO VENTILATOREN, www.maico-fans.com - We are not responsible for mistakes or printing errors and retain the
right to make technical modifications without giving prior notice Page 3
1RS shutter
2EZF/DZF wall-mounted fan
3ZFF air filter
4Servomotor
5Electric or electronic switching systems
6EZQ/DZQ wall-mounted fan
7AS shutter
Wall installation with extension sleeve
■Insert the conical wall mounting ring of the fan into the VH extension sleeve using light pressure.
■Insert the fan into the wall together with the extension sleeve.
■Fill the gap between the extension sleeve and the external wall with plaster or add another extension sleeve of a suitable
length.
■Notice: Do not install the extension sleeve on the fan side flush with the plaster, as then the fan cannot be mounted on the
wall.

INSTALLATION INSTRUCTIONS
EZQ 40/4 B
Version: 2018-01-25 - MAICO VENTILATOREN, www.maico-fans.com - We are not responsible for mistakes or printing errors and retain the
right to make technical modifications without giving prior notice Page 4
1Fan
2External wall
3AS shutter, airstream-operated
4VH extension sleeve
5RS shutter, electrically or manually operated
Installation in thin walls
■Use a connection frame; see Recommended Accessories: The fan is fastened using the supplied fixing brackets
1Fan
2Connection frame
3Shutter, airstream-operated
4External wall