Main Access 200601T User manual

Assembly Instructions for Model #200601T iStep
1004 Jaycox Rd, Avon OH 44011
1-888-333-1134
www.GoMainAccess.com

iSTEP
Model #200601T Assembly Instructions

For Questions Regarding Installation, Please Contact Main Access Customer Service 1-888-333-1134
Step 3: Repeat steps 1 & 2 on the right side of the
step.
Step 4: Align the holes on the lower left riser with
the mushroom caps on the lower step tread.
Model #200601T
Step 1: Align the holes on upper left riser with with
mushroom caps on the upper step tread.
Step 2: Snap into place with a rubber mallet.
Step 6: Repeat steps 4 & 5 on the right side of the
step.
Step 5: Snap mushroom caps into place using
rubber mallet.

Step 11: Insert mid riser brace in between risers
and over the tabs.
Step 12: Insert lower handrails into the holes on
either side of the lower step tread.
iSTEP
Model #200601T Assmebly Instructions
Step 7: Insert the tabs from lower step assembly to
the slots of the upper step assembly.
Step 8: Align ballast tray between all four risers
under the step.
Step 9: Snap tabs from upper and lower risers into
the ballast tray with a rubber mallet.
Step 10: Insert top step support brace in between
uppers risers.

Step 15: Place upper handrail down over the
handrail connector.
Step 16: Drill #14 x 1 1/4" screws into handrails
through all upper and lower risers.
Step 17: Drill #8 x 1" screws into four dimples on
step tread.
Step 18: Insert the socket cap into the unused hole
in middle step.
For Questions Regarding Installation, Please Contact Main Access Customer Service 1-888-333-1134
Model #200601T
Step 13: Insert the smaller end of the handrail
connector into the top of the lower handrail.
Step 14: Place deck connector on the upper
handrail and place into the hole on the top step.

For Questions Regarding Installation, Please Contact Main Access Customer Service 1-888-333-1134 or
[email protected]
iSTEP
Model #200601T Assmebly Instructions
Step 21: Pool Installation
Step 22: Deck Mount Installation
*Optional* Purchase (2) Anchors (#200888) to weigh
down the iStep. Sand not inlcuded.
All Finished!
Note: Two people are required for installation.
A total weight of approximately 100 lbs. is
required to keep the step from moving once in
place under water. With the assistance of another
person, carefully place the step in the pool. Place
the two sealed bags of sand (not included) in
ballast bags (M) over the ballast tray (D) to hold
the step in place. Walk step back againast the pool
wall to prevent swim behind hazards.
With the step in position close to the pool wall,
slide the deck connectors (H) intstallation position
on either the pool top seat or pool deck. Secure to
the deck with two #8 x 1" screws (N). Use a
minimum of two screws per deck connector.
Secure each deck connector (H) to each upper
handrail (E1) by using a single #8 x 1" screw.

Be Sure to Check Out Other Great Products From Main Access!
Mount it to your step or hang it from the return!
Use them to easily weigh down your pool step!
Luxury Pool Floats!
Light-up Floating Globes and Furniture!