Majestic UFO Quick start guide

Troubleshooting Guide
Weak or missing signal - check LED on power inserter - check LED on UFO Both LED's must be ON for the UFO to work Interference, Herring-bone pattern. White horizontal stripes in the picture. Ghosting, Double Pictures
Description: Type Channels Reference No Electrical Data: Frequency Gain Noise figure Output voltage Return loss Impedance Horizontal Bandwidth Power supply
Omnidirectional antenna for TV and FM Radio reception with built in amplifier. TV Ch2 - Ch69 + FM 109680
. 45 - 860 Mhz 28dB 2.5dB 108dB μV > 10dB 75 Ohm 360 degrees 12 - 24V / 50mA
Remove the cables one by one to find the defective one, then replace or repair. Increase distance Increase UFO Height Changing position by a few metres often solves this.
NO light indicates no voltage. Often this is caused by a short in one of the cable connectors. Interference is often caused by different electronic equipment - mobile phones, computers etc being used in close proximity to the UFO. Ghosting is caused by the TV signal being reflected by buildings, large ships etc.
Technical Data
Assembly and Mounting Instructions
www.majestic-global.com
Television and FM Antenna
Problem Possible Reason Solution
12V or 24V
Power inserter / Signal splitter
Battery
IN OUT OUT
Television
FM Tuner
UFO

Attaching the Connectors Mounting on a horizontal surface.
Positioning the antenna: Screw Bracket to Desk Mount Position the mount, and mark off holes for fixing. Strip cable to depths shown (mm) Attach supplied coaxial connectors.
Insert Mast Bracket Pull Bracket through Attach to mast with appropriate fixture
A: B:
Push forward Push Down
Ensure that the UFO shells are fully mated to the bracket
Mounting on mast.
Connecting the cable. Mount UFO on base. Screws for extra strengh.