Major Manufacturing HIT-66-251 User manual

INSTRUCTIONS
FOR
HIT-66-251 TEMPLATE
FOR
KABA
660/760/770/790/79M
1825 VIA BURTON
ANAHEIM CA 92806
714-772-5202 / FAX [phone]
EMAIL: [e-mail]
WEB: WWW.MAJORMFG.COM
WHEN USING POWER TOOLS
ALWAYS WEAR
EYE AND EAR PROTECTION!!

THINK
SAFETY!!
WHEN USING POWER TOOLS
ALWAYS WEAR
EYE PROTECTION!!
Before attempting any installation know
how to safely use the power tools involved.
Be sure all bits and cutters are sharp and
in good condition and all power tools and
extension cords are in good working order
and properly grounded. AND MOST
IMPORTANTLY, BE SURE TO WEAR,
EYE AND EAR PROTECTION.
PAGE 1
Copyright 2010—Major Manufacturing

With both clamps
opened equally, install
both inside and outside
templates to the HIT-66
clamp as shown. Do not
tighten the 10-32
screws at this time.
When all screws have
been loosely installed,
then it is ok to tighten.
Install the alignment guide to
either side of the template
set. This is used to align the
template with the mortise
pocket.
Shown is a standard
mortise pocket, we will
use this as a basis for
the KABA install.
PAGE 2

Install the mortise lock positioning plate. The
plate will fit into the 1-1/4” x 8” faceplate cut
out. There will be a 3/8” diameter pin
centered on the plate. There is no top or
bottom to worry about.
Slide the HIT-66 template with the alignment
guide alignment pin and tighten to door.
Alternate tightening between the top and
bottom clamp. Do not attempt to tighten one
clamp all the way at once.
For drilling wood or metal doors, use a
standard twist drill as shown.
PAGE 3

Drill the four 1/2”
diameter holes on the
drill guide. The two
top holes and the
bottom hole are lock
mounting holes for
thru-bolt mounting.
The center 1/2” hole
is for the t-turn. Drill
half way from both
sides of the door.
The center 1” diameter
guide bushing is for
the drive spindle. A
hole saw shown at left
can be used on both
wood or steel doors,
dill half way to the
mortise pocket from
both sides of door.
PAGE 4
When all holes have been drilled remove the
The HIT-66 drill guide from the door.

PAGE 5
Completed lock prep.
Install lock per manufacturers directions.
That’s all there is to it!
Visit our web site at www.majormfg.com for more
information on lock templates and a complete listing of all
the tools we have available. While there, sign up for our
newsletter and we will email new product
information directly to you.