5ENGLISH
Save all warnings and instruc-
tions for future reference.
The term "power tool" in the warnings refers to your
(cordless) power tool.
Hammer drill safety warnings
Safety instructions for all operations
1. Wear ear protectors when impact drilling.
2. Use the auxiliary handle(s). Loss of control can
3. Hold the power tool by insulated gripping
surfaces, when performing an operation where
the cutting accessory may contact hidden wir-
ing or its own cord. Cutting accessory contacting
power tool "live" and could give the operator an
electric shock.
4.
sure no one is below when using the tool in
high locations.
5.
6. Keep hands away from rotating parts.
7. Do not leave the tool running. Operate the tool
only when hand-held.
8.
immediately after operation; they may be
9. Some material contains chemicals which may
-
safety data.
10. If the drill bit cannot be loosened even you
open the jaws, use pliers to pull it out. In such a
Safety instructions when using long drill bits
1. Never operate at higher speed than the max-
imum speed rating of the drill bit. At higher
freely without contacting the workpiece, resulting
2. Always start drilling at low speed and with the
At higher
freely without contacting the workpiece, resulting
3. Apply pressure only in direct line with the bit
and do not apply excessive pressure. Bits can
SAVE THESE INSTRUCTIONS.
WARNING: DO NOT let comfort or familiarity
with product (gained from repeated use) replace
strict adherence to safety rules for the subject
product. MISUSE or failure to follow the safety
rules stated in this instruction manual may cause
serious personal injury.
FUNCTIONAL DESCRIPTION
CAUTION: Always be sure that the tool is
Switch action
WARNING:
Before plugging in the tool, always
and returns to the "OFF" position when released.
Fig.1: 1. Switch trigger 2.
To start the tool, simply pull the switch trigger. Tool
trigger. Release the switch trigger to stop.
For continuous operation, pull the switch trigger, push in the lock
the locked position, pull the switch trigger fully, then release it.
CAUTION: -
tion for ease of operator comfort during extended
Lighting up the lamp
For model HP1641F
Fig.2: 1. Switch trigger 2. Lamp
CAUTION:
source of light directly.
To turn on the lamp, pull the switch trigger. Release the
NOTE: Do not use thinner or gasoline to clean the
lamp. Such solvents may damage it.
NOTE:
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
Reversing switch action
CAUTION:
rotation before operation.
NOTICE:
Use the reversing switch only after the
tool comes to a complete stop. Changing the direction
NOTICE: When changing the direction of rota-
tion, be sure to fully set the reversing switch to
position (A side) or (B side). Otherwise, when
the switch trigger is pulled, the motor may not rotate
or the tool may not work properly.
Fig.3: 1. Reversing switch lever
This tool has a reversing switch to change the direc-
tion of rotation. Move the reversing switch lever to the
position (A side) for clockwise rotation or to the posi-
tion (B side) for counterclockwise rotation.
