Mania BIKEPRO User manual

INSTRUCTION MANUAL
BIKEPRO 4-IN-1 BIKE LIGHT
PACKAGE CONTENTS
•4-in-1 bike light
•Micro USB cable
•Bike mount base
•Horn
TECHNICAL SPECIFICATIONS
•Lamps: 2 × XM-L T6 fluorescent bulbs
•Brightness: 400 lm
•Strong / weak / flashing light modes
•Horn sound volume: 130 dB
•Battery capacity: 4000 mAh lithium-ion
battery
•Charging time: 5 h
•Output current: 0,8 A
•Material: ABS, PS, silica gel
•Size: 11,5 ×5,5 ×5 cm
•Waterproof rating: IPX-3
COMPONENTS
(1) Phone holder clip
(2) Bike mount quick release
(3) LED lights
(4) Horn speaker
(5) Bike mount base
(6) Horn button (with rubber fastening belt)
(7) Power output USB port
(8) Charging micro USB port
(9) Light mode / on-off button
INSTALLATION
•First, unscrew the bike mount base’s
tightening screw and decidewhere you want
to put the 4-in-1 bike light.
•Place the mount wherever on the handlebar
(make sure that the non-slip spacers are
inserted into the mount) and tighten the
tightening screw.
•Slide the 4-in-1 bike light into the base and
enjoy the product.
•To remove the bike light press on the bike
mount quick release and slide the light off.
•The horn button should also be fastened to
the handlebar with the rubber belt that is
part of the horn.
•The product battery is already partially
charged when it arrives, but it is highly
advisable that you leave it charging for 5 h
before first use.

FEATURES AND HOW TO USE THEM
OBIKE LIGHT
•There are three different light modes: Bright
light, low light, and flashing light.
•Press the white button (no. 9) once to turn
on the bright light.
•If you press the button again, it will switch to
low light.
•Pressing the button yet again will switch it to
the flashing light mode.
•Press the button again to turn the light off.
•In short, pressing the white button cycles the
different light modes.
OPHONE HOLDER
•The phone holder is the top-most part of the
BikePro 4-in-1 bike light (no. 1).
•Slide the phone in and ride your bike with no
worries that the phone would fall out.
•It can hold phones of all sizes from 4” (10,2
cm) to 6.3” (16 cm).
OHORN
•The horn speaker is on the bottom side of
the product (no. 4).
•Sound the horn by pressing the horn button
(no. 6).
•There are 5 different horn sounds available.
•To change the sound of the horn press and
hold the horn button for four seconds.
•Fasten the horn button to the handlebar of
your bike with the rubber fastening belt
OPOWER-BANK
•The product features a 4000 mAh power-
bank battery.
•The USB and the micro USB ports are under
the power button, behind a rubber seal.
•To charge the power-bank, connect it (no.
8) to a charger with the included micro USB
cable.
•To charge your phone with the power-bank,
plug a charging cable into the power-bank
(no. 7) and the phone will start charging
automatically.
•If the battery capacity of the power-bank is
below 30%, it will not charge your phone,
but rather conserve the energy for other
operations.
IMPORTANT
•Pay attention to the road when using this
item on a bike.
•Always turn on the light when using the
product on a bike at night.
•Waterproofing is sufficient for rainy
conditions. Do not fully submerge into
water.
•Check the tightening screw before use to
make sure the product is securely fastened
to your bike.
•Slide the product all the way back on the
bike mount until it clicks to make sure it is
securely fastened to your bike.
•Do not use your phone during cycling to
avoid accidents.
•Only use the included USB cable to charge
the power-bank for best performance and to
avoid damage.
•Improper use will void the warranty.
•This device has no user serviceable
components. Do not disassemble.
•Turn off when not in use.
WARRANTY
The warranty is valid for 24 months. You can claim
it from DFVU d.o.o., Liparjeva 6a, 1234 Mengeš,
Slovenia, for a replacement product or a refund.
Send us your order number and purchase date in
the email, which is available by clicking on our logo
in the bottom right corner. The product has a
lifetime of 24 months from the date of collection.
WEEE disposal and recycling symbol.
The WEEE symbol is attached to the
product in compliance with the EU
directive 2012/19/EU on Waste
Electrical and Electronic Equipment
(WEEE). It is intended to deter the
improper disposal of this product and
to promote reuse and recycling.