Mania EASYWINDOW User manual
INSTRUCTION MANUAL
3D WINDOW CLEANER EASYWINDOW
COMPONENTS
•Double side magnetic window cleaner
•2 extra cleaning cloths
•4 extra buckles
•3 extra rubber strips
•Anti-pinch spacer
•User manual
TECHNICAL SPECIFICATIONS
•Material: ABS, magnet, rubber, sponge
•Size: 160 x 135 x 40mm
•Applicative range: 3–8mm, 8–15mm, 15–26mm
FEATURES
1. Adjustable safety cord
2. Holding handle
3. Plastic casing
4. High-performance magnet
5. Rubber strip
6. Cleaning cloth
7. Fastening buckle
8. Foam sponge
PREPARING THE CLEANER
1. Separate the two pieces of
the magnetic cleaner and
remove the anti-pinch spacer.
2. Soak the triangle tip with
cleaning cloth on both parts
of the magnetic cleaner.
3. Drop a little detergent on the
cloth and rub both tips of the
magnetic cleaner together.
USING THE CLEANER
1. Tie a safety cord to your finger, wrist or
tie it next to the windows frame to
meet safety standards.
2. Put the side with the attached cord on
the outer part of the window and hold
it. Position the inner part on the inner
side of the window so that you can feel
magnet pull.
3. Keep the triangle up or down and foam
horizontally first. Then foam all around.
4. Clean the glass with the cleaning cloth
at the front and the rubber strip at the
back.
5. Position the cleaner transverse to the
window with the tip diagonally down
so that the water is pushed down and
leaves no trace.
6. Drive all the water down to the bottom
of the window and then wipe excess
water in the corner with a towel.
REPLACEMENT OF PARTS
1. Rotate the buckle for 90
degrees. The buckle is unlocked
when in a horizontal position.
Change the cloth with a clean
one. Rotate the buckle back in a
vertical position to lock the
cloth in place.
2. Replace the rubber strip with a
pulling motion on the side of
the window cleaner.
3. Insert the rubber strip back in
slot in the same direction that
the previous strip was. (Mind
the bump at one end of the
rubber strip.)
MAINTENANCE & CLEANING
1. Clean the cloth with clean water
2. Place the anti-pinch spacer
according to the shape to prevent
the deformation of the cleaner.
3. After cleaning the cleaner, close
the two pieces. Let it dry in the
shade.
