Manitowoc D320 User manual

Instruction Sheet Subject: D Model or A Model Bin Door, Hinge Pins or
Door Hinge Bracket Replacement
1 of 2
Document Number: 000015465 Rev00 5/18
MANITOWOC ICE
2110 SOUTH 26TH STREET, MANITOWOC, WI 54220
844724CARE
WWW.MANITOWOCICE.COM
nWarning
Authorized Service Representatives are obligated to follow
industry standard safety procedures, including, but not
limited to, local/national regulations for disconnection
/ lock out / tag out procedures for all utilities including
electric, gas, water and steam.
DANGER
Disconnect electric power to the ice machine at the electric
switch box before proceeding. Failure to disconnect the
power at the main power supply disconnect could result
in serious injury or death. The power switch DOES NOT
disconnect all incoming power.
nWarning
This equipment contains refrigerant charge. Procedures
must be performed by a properly trained and certified
refrigeration technician aware of the dangers of dealing
with refrigerant charged equipment.
nWarning
Remove all removable panels before lifting and installing
and use appropriate safety equipment during installation
and servicing. Two or more people are required to lift or
move this appliance to prevent tipping and/or injury.
Install new bin door or bin door brackets
Step 1 Remove the foam tape from the front top rail
corners to access screws. Remove the 2 screws that secure
the top trim on D bins or 4 screws on A bins, then remove
the top trim.
Step 2 Open the bin door fully until it locks in place, then
remove the bottom screw from the left and right bin door
bracket.
Step 3 Close the bin door fully and remove the top screw
from the left and right bin door brackets, then remove
door/brackets from bin.
Step 4 Install new bin door on bin door brackets or new
brackets on existing bin door.
Step 5 Close the door fully and install top screws in door
hinge brackets, then open fully and install bottom screws in
door hinge brackets

2 of 2
Document Number: 000015465 Rev00 5/18
Subject: D Model or A Model Bin Door, Hinge Pins or Door Hinge Bracket Replacement
Install new door pin sleeves in bin door brackets
Step 1 Remove the foam tape from the front top rail
corners to access screws. Remove the 2 screws that secure
the top trim Remove the 2 screws that secure the top trim on
D bins or 4 screws on A bins, then remove the top trim.
Step 2 Open the bin door fully until it locks in place, then
remove the bottom screw from the left and right bin door
bracket.
Step 3 Close the bin door fully and remove the top screw
from the left and right bin door brackets, then remove
door/brackets from bin.
Step 4 Slide left and right door pins out of door pin
sockets and insert replacement door pins.
NOTE: If replacing door pin sockets, remove screw and slide
door pin sockets out of door. Reverse procedure to install
replacement door pin sockets.
Step 5 Install left and right bin door brackets on door pins.
Step 6 Place door on bin and install top screws in left and
right door brackets.
Step 7 Open bin door and install bottom screws in door
hinge brackets and close door.
Step 8 Reinstall top rail trim, secure with screws and
reapply gasket material.