Sapho Phantom Quick guide
Phantom Sensor Trash Bin
Use instructions
Trouble Shooting
Important Safety Instructions
Battery instructions
1. No lights on – Please make sure the batteries are installed correctly or try new batteries.
2. No response from sensor – The lid may have been closed by hand in manual mode. Pressing
„CLOSE“ will reset the modes.
• This appliance is intended for hosehold /commercial use only, and should not be used for any
other purpose. Any other use may invalidate the warranty and might be dangerous.
• This appliance is not intended for use by person (including children) with reduced physical, sen-
sory or mental capabilities, or lack of experince and knowledge, unless they have been given su-
pervision or instructions concerning use of the appliance by a person responsible for their safety.
• This product contains electronic parts inside the lid, do not dip the lid into the water or use corro-
sive liquid to clean the product. Use dry cloth to clean the operation indicator of the lid, use a soft
damp cloth to clean the body and liner (rim), wipe dry with a clean cloth.
• Children should be supervised to ensure that they do not play with the appliance.
1. Only adults should handle batteries.
2. Always purchase the correct size and grade of battery most suitable for the intended use.
3. Always replace the whole set of batteries a tone time, taking care not to mix old and new ones,
or batteries of different types.
4. Risk of explosion if battery is replaced by an incorrect type.
5. Clean the battery contacts and also those of the device prior to battery installation.
6. Ensure the batteries are installed correctly with regard to polarity (+and -).
7. Remove batteries from equipment which is not to be used for an extendedperiod of time.
8. Remove used batteries promptly.
9. For recycling and disposal of batteries to protect the enviroment, please check the internet or
your local phone directory for local recycling centers and/or follow government regulations.
Parts list Functions
Battery instalation
Lighting Indications
Fixing the Trash Bag
1. Flap
2. Lid
3. Button panel
4. Body
5. Switch button
6. Battery cover
7. Plastic liner
Effective range:
This product will sense when an object passes through the sen-
sors range, which is about 7,87in/20cm (± 1,97in/5cm) above the
panel.
Modes:
Stand-by mode – The lid stays closed and the bin is waiting for a
signal to open. A red light flashes to indicate this mode.
Sensor mode – When the sensor unit spots the signal, the lid will
open. The lid will stay open as long as the signal stays in the effec-
tive range. After the object is removed from the range, the lid will
close in 5 seconds.
Manual mode - Users can open the lid by pressing the „OPEN“
button. The lid will stay open until the „CLOSE“ button is pressed.
During this mode, a red light in the middle will ash.
1. Wrap the top rim of the liner with plastic bag (please
leave the handle outside for easy operation);
2. Press the excess bag into the bag xer on the liner .
1. Open the battery cover and take out old
batteries (if there is any)
2. Install the batteries into battery box,
please mind the polarity (6xAA – not
included)
3. Push battery cover to close position, make
sure the clip snap rmly
4. Turn on the swich button
Red light in the middle indica-
te Waiting/Manual mode
The lights turn on from left to
right when the sensor spots
open signal
The lights turn off from right
to left when the open signal is
removed
